Kenmore 17921 User Manual download pdf (Page 12)

WINDING THE BOBBIN

1.

2.

Place thread on Telescoping Spool Pin.

Draw thread through Rear Thread Guide

and Bobbin Winder Tension Disc as

indicated.

Pull end of thread through any hole in

bobbin; place bobbin on Bobbin Winder

Shaft with end of thread coming from top

of bobbin as shown above.

3. Push Bobbin Winder Latch against bobbin

until it clicks. Then pull Hand Wheel away

from machine to disengage clutch (see

diagram below). Hold end of thread

coming from bobbin (see above) and step

on foot control. After several rotations of

bobbin release thread.

4. When bobbin is full, winding stops

automatically. Push in Hand Wheel.

Remove bobbin from shaft and trim

thread end.

* Treat Hand Wheel as a "clutch"

It controls the needle mechanism so that

when pulled out (disengaged), the rest of

the machine will not operate while the

bobbin is being wound.

For best stitching results use clear plastic

lightweight bobbins when stitching at high

speed with widest and longest stitch

setting.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 64 65

Comments to this Manuals

No comments