Kenmore ELITE 795.7105 User Manual download pdf (Page 38)

CONNECTING THE WATER LINE

8. FLUSH OUT THE TUBING

Turn the main water supply on

and flush out the tubing until the

water is clear.

Shut the water off at the water

valve after about one quart of

water has been flushed through

the tubing.

9. CONNECT THE TUBING TO THE

REFRIGERATOR

NOTE:

• Before making the connection to the refrigerator,

be sure the refrigerator power cord is not

plugged into the wall outlet.

1. Remove the plastic flexible cap from the water

valve.

2. Place the compression nut and ferrule (sleeve)

onto the end of the tubing as shown.

3. Insert the end of the copper tubing into the

connection as far as possible. While holding the

tubing, tighten the fitting.

A CAUTION; Check to see if leaks occur at water

line connections.

10. TURN THE WATER ON AT THE

SHUTOFF VALVE

Tighten any connections that leak.

11. PLUG IN THE REFRIGERATOR

Arrange the coil of tubing so that it does not

vibrate against the back of the refrigerator or

against the wall. Push the refrigerator back to

the wall.

12. START THE ICEMAKER

Set the icemaker power switch to the On (I)

position.

NOTE: A newly installed refrigerator may take

several hours to start producing ice.

A CAUTION; Check to see if water dripping

occurs at water line connections.

38

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44 45 46

Comments to this Manuals

No comments