Kenmore 71212 Owner's Manual download pdf (Page 12)

INSTALLATION INSTRUCTIONS

Complete the Installation

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong. Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

re, or electrical shock.

Plug into a grounded 3 prong outlet.

Start the icemaker. Move the feeler arm to the ON

(down) position. The icemaker will not begin to operate

until it reaches its operating temperature of 15°F (-9°C)

or below. It will then begin operation automatically.

NOTE:

Allow 24 hours to produce the rst batch of ice.

Discard the rst three batches of ice produced. Allow 3

days to completely ll ice container.

In lower water pressure conditions, the water valve may

turn on up to 3times to deliver enough water to the

icemaker.

Front Base Grille

The front base grille which was packaged inside the

refrigerator for shipment and should be installed after the

refrigerator has been leveled.

Align the base grille to the screw holes.

(The cut out side on the base grille installs around the

lower hinge of the door.)

Secure the base grille into screw holes with Phillips

screwdriver.

NOTE:

Reverse these steps to remove this style of base

grille.

Feeler arm in the STOP (up)

position.

Feeler arm in the ON (down)

position.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

No comments

Kenmore 71212 Owner's Manual Page 12