Kenmore 70013 Owner's Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
11
Controls
User Interface (UI) Controls
Ref. Temp Temperature setting decreases every time
the Ref. Temp indicator is pressed. It cycles
between 44°F and 34°F. When 34°F is
shown, pressing Ref. Temp again will loop
back to 44°F. Control temperatures range
from +34°F / +1°C to +44°F / +7°C
Frz. Temp Temperature setting decreases every time
the Frz. Temp indicator is pressed. It cycles
between +7°F and -7°F. When -7°F is
shown, pressing Frz. Temp again will loop
back to +7°F. Control temperatures range
from -7°F / -22°C to +7°F / -14°C.
Modes Press the Modes key, the corresponding
modes will be cycling on a loop
Lock Hold
3s
Locks the UI so Temp cannot be changed
without unlocking.
The UI Controls auto-lock automatically after 30 seconds
of no keys or doors operation.
You MUST unlock the UI to adjust settings.
Change °F to °C
1 Unlock the UI.
2 Hold down the Frz. Temp & Ref. Temp at the same
time for 3 seconds. UI will change from °F to °C.
To change °C to °F, repeat the above steps.
Modes Setting
Unlock the UI and press the Modes key. The corresponding
modes will cycle on a loop as shown below.
Fresh Food Compartment Cycle Settings:
Quick Chill-> Quick Freeze ->Quick Chill/Quick Freeze-
>Vacation->None->Quick Chill.
Under Quick Chill mode the fresh food compartment
defaults to 34°F (1°C). Activate Quick Chill mode
to increase the rate of cooling food. It deactivates
automatically after 2.5 hours. When exiting the Quick
Chill mode the setting restores back to the temperature set
before going into Quick Chill mode.
Under Quick Freeze mode the freezer defaults to -7°F
(-22°C). Activate Quick Freeze mode to increase the rate
of freezing food. It deactivates automatically after 6
hours. When exiting the Quick Freeze mode the setting
restores back to the temperature set before going into
Quick Freeze mode.
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Comments to this Manuals

No comments