Kenmore C970-400323 User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
7
ENGLISH
General Care & Cleaning
Cleaning Various Parts of Your Cooktop
Before cleaning any part of the cooktop, be sure all controls are turned OFF and the cooktop is COOL. REMOVE SPILLOVERS
AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS NOW WILL REDUCE THE DIFFICULTY AND
EXTENT OF A MAJOR CLEANING LATER.
How to Clean
Use hot, soapy water and a cloth or paper towel. Dry with a clean cloth.
For general cleaning
, use hot soapy water and a cloth.
For more difficult soils and built-up
grease
, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes. Rinse
with a damp cloth and dry. DO NOT use abrasive cleaners on any of these materials; they
can scratch or dull the finish.
Wipe the control panel clean after each use. Before cleaning the control panel,
turn all controls
to OFF and remove the control knobs. To remove, pull each knob straight off the shaft. Clean
using hot, soapy water and a cloth. Be sure to squeeze excess water from the cloth before
wiping the panel; especially when wiping around the controls. Excess water in or around the
controls may cause damage to the appliance. To replace knobs after cleaning, line up the
flat sides of both the knob and the shaft; then push the knob into place.
Surface elements can be unplugged and removed to make cleaning the drip bowls easier.
The surface elements clean themselves when they are turned on. Food spilled on a hot
element will burn off. Food spilled on a cool element can be cleaned with a damp cloth—any
remaining soil will burn off the next time the element is used. NEVER IMMERSE A
SURFACE ELEMENT IN WATER. To remove surface elements and drip bowls, follow the
instructions under General Cleaning.
To clean drip bowls, wash in hot, soapy water or in the dishwasher. Rinse and dry while still
warm. Hard-to-remove, burned-on soils can be removed by soaking the drip bowls for about
20 minutes in a slightly diluted liquid cleanser or a solution made of equal parts ammonia and
water. A nylon scrubber may be used after soaking. DO NOT use abrasive cleansers or steel
wool, as they will scratch the surface. Always rinse with clean water and polish, and dry with
a soft cloth or paper towel. To replace drip bowls and surface elements, follow the instructions
under General Cleaning.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1 solution
of clear water and ammonia.
If necessary
, cover difficult spots with an ammonia-soaked
paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth, and then scrub
with a soap-filled scouring pad. Rinse and wipe dry with a clean cloth or paper towel. Remove
all cleaners or the porcelain may become damaged during future heating. DO NOT use spray
oven cleaners on the cooktop.
Clean with hot, soapy water and a dishcloth. Rinse with clean water and cloth. Do not use
cleaners with high concentrations of chlorides or chlorines. Do not use harsh scrubbing
cleaners. Only use kitchen cleaners that are especially made for cleaning stainless steel.
Always be sure to rinse the cleaners off from the surface as bluish stains may occur during
heating that cannot be removed.
Surfaces
Aluminum (Trim Pieces)
Painted and Plastic
Control Knobs, Body Parts,
and Decorative Trim
Control Panel
Surface Elements and Drip
Bowls
Porcelain Enamel
Cooktop
Stainless Steel, Chrome
parts, Decorative Trim
Cooktop
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments