Kenmore 3405602 User Manual download pdf (Page 19)

STEP 5. Connect neutral grounding wire

and the neutral wire (white or center) of

direct wire cable under the center screw

of terminal block.

Center silver-colored

terminal block screw

4-Wire Connection with Direct Wire

and Frame-Grounding Conductor

STEP 6. Place the hook-shaped end of

the wire over the terminal block screw.

The open side of the hook should face

to the right. Squeeze hook end of wire

together to form a loop.

JLJLJC:

STEP 7. Connect the other two wires

to outer terminal block screws. Use the

same method described in STEP 6.

STEP 8. Connect the direct wire cable

(bare) grounding wire to the external

grounding conductor screw. Tighten all

terminal block screws firmly.

STEP 9. Tighten the strain relief screws.

STEP 10. Insert tab of terminal block

cover into slot of the dryer rear panel.

Secure cover with hold-down screw.

Proceed with Exhaust Installation.

See “CONNECT EXHAUST” on

this page.

D. CONNECT EXHAUST

for your Benefit

A properly exhausted dryer will give

you the shortest drying time, lower

your utility bill, and extend the life of

the dryer.

A WARNING

M

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions

can result in death or fire.

■ Replace plastic exhaust vent with

heavy metal or flexible metal vent.

• Do not use non-metal flexible vent,

metal vent that is smaller than four

inches in diameter, or exhaust hoods

with magnetic latches.

• Do not exhaust dryer into a chimney,

furnace cold air duct, attic or crawl space,

or any other duct used for venting.

» Do not install flexible metal vent in

enclosed walls, ceilings, or floors.

• If using an existing exhaust system,

disconnect vent from the dryer and

clean one section at a time until you

reach the exhaust hood. To clean out

lint, you can use the hose attachment

on your vacuum or, use a pole or wire

with a feather duster or rag attached.

- Make sure exhaust hood is not plugged

with lint. Follow the instructions in this

section to reinstall your vent system.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Comments to this Manuals

No comments