Kenmore 92562 Owner's Manual download pdf (Page 32)

Before You Call

Drip bowls have changing or

distorting colors.

Bottom of cookware extends beyond surface element and touches cooktop surface. This can

cause high enough temperatures to discolor drip bowls. DO NOT use cookware of this type.

Pan sizes should match the size of the element. Replacement drip bowls may be purchased

from your appliance dealer.

Self Clean Problems

Self clean does not work Oven control not set properly. See “Self Clean” on page 23

Oven racks discolored or do not

slide easily

Oven racks left in oven cavity during self clean. Remove oven racks from oven cavity before

starting a self-clean cycle. Clean by using a mild abrasive cleaner following manufacturer's

instructions. Rinse with clean water, dry, and replace in oven.

Soil not completely removed after

self clean

Self clean was interrupted. Review instructions on “Self Clean” on page 23.

Excessive spills on oven bottom. Remove excessive spills before starting self clean.

Failure to clean soil from the oven frame, the door liner outside the oven door gasket, and

the small area at the front center of the oven bottom. These areas are not in the self-

cleaning area, but get hot enough to burn on residue. Clean these areas before starting the

self-cleaning cycle. Burned-on residue can be cleaned with a stiff nylon brush and water or a

nylon scrubber. Be careful not to damage the oven gasket

Other Problems

Appliance is not level.

Be sure the floor is level, strong, and stable enough to adequately support the range.

If the floor is sagging or sloping, contact a carpenter to correct the situation.

Poor installation. Place the oven rack in the center of the oven. Place a level on the oven

rack. Adjust the leveling legs at the base of the appliance until the rack is level.

Kitchen cabinet alignment may make range appear not level. Be sure cabinets are square

and have sufficient room for appliance clearance.

Cannot move appliance easily.

Appliance must be accessible for

service.

Cabinets not square or are built in too tightly. Contact the builder or installer to make the

appliance accessible.

Carpet interferes with appliance. Provide sufficient space so the appliance can be lifted over

carpet. Installation over carpet is not advised. See the installation instructions for guidelines

specific to your appliance.

Oven light does not work. Be sure the oven light is secure in the socket. See “Replacing the Oven Light” on page 30.

Problem Cause / Solution

1 2 ... 27 28 29 30 31 32 33

No comments

Kenmore 92562 Owner's Manual Page 32