Kenmore 24'' Manual Clean Gas Wall Oven 3052 Owner's Manual download pdf (Page 7)

Oven Vent and

Oven Vent

Location

Racks

Some models are equipped with a blower which runs in baking

and self-cleaning mode to keep a[[ internal components at a coo[ temperature.

The blower may keep running even if the oven has been turned off, until the

components have cooled down.

Oven Vent Location

The oven is vented through the upper control panel trim. When the oven is on, warm

air is released through the vent. This venting is necessary for proper air circulation in the

oven and good baking results.

Arranging Oven Racks

ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO

OPERATING THE OVEN), Always use oven mitts when using the oven.

To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and

slide out.

To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front

of the rack upward and slide the rack back into place.

Air Circulation in the Oven

If using 1 rack, place in center of oven. If using multiple racks, stagger cookware

as shown.

For best air circulation and baking results allow 2-4" (5-10 cm) around the

cookware for proper air circulation and be sure pans and cookware do not touch

each other, the oven door, sides or back of the oven cavity. The hot air must

circulate around the pans and cookware inthe oven for even heat to reach around

the food.

1 Oven Rack

Multiple Oven Racks

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Kenmore 24'' Manual Clean Gas Wall Oven 3052 Owner's Manual Page 7