Kenmore 6 Burner Stainless Steel Front Gas Grill With Storage Owner's Manual download pdf (Page 40)

40 • 146.23686310

Side Burner

 Loosen side burner in side shelf by unscrewing and removing the two front screws holding the burner in

place. See A. Note: Do not loosen electrode screw.

 Side burner black ground line has two wires running into one connector tip. Run longer wire through vent

hole above ignition module in side panel into right cabinet. Securely attach tip of long wire to connector

pin on regulator valve assembly. See B.

 Remove the 2 pre-installed screws from the valve control stem and set them aside. See C.

 Insert valve control stem through hole in fascia. Attach bezel to fascia and valve face with previously

removed 2 screws. Attach bezel with black mark facing up. See D.

 Place side burner tube over the valve orifice, making sure the orifice is inside the burner tube. Reattach

side burner to side shelf with the 2 previously removed screws. See E.

 Run orange side burner ignition wire shown E from burner through side panel vent hole and into main

cabinet. Connect wire in later step.

 Push control knob onto side burner valve control stem, and place cooking grate onto burner. See F.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 99 100

No comments

Kenmore 6 Burner Stainless Steel Front Gas Grill With Storage Owner's Manual Page 40