Kenmore Elite 30'' Down Draft Hood 59960 Specifications download pdf (Page 9)

_NSTALL ELECTRICAL W_RING

1. The Downdraft Blower system draws 4 AMPS and requires

a 120 VAC, 60 Hz circuit.

2. The unit has a 18 in. Iong power cord with a 3-pronged plug.

Plan to provide a grounded outlet in a location which will

allow the unit's power cord to reach.

tMPORTANT -LOCATION OF ELECTRICAL OUTLET:

If Model 59960 is being installed in a 30" wide cabineL_

or-

If Model 59966 is being installed in a 36" wide cabinet._

...the outlet cannot be mocated on the back wall of

cabinet.

in these cases, the width of the downdraft covers nearly

the entire width of the back waII of the cabinet. So you

must either:

,, mount the electricat box to aside wall or cabinet floor

- at least 12 inches from the back wail.

,, mount the electrical box to a wall stud behind the

cabinet -where itwilI not be covered by the downd raft.

Then provide a clearance hole in the back wail of the

cabinet.

3. Mount a standard wiring box, with 3-pronged receptacle,

inside the cabinet. Make sure the downdraft's power cord

can easily reach it.

4. Run appropriate power cable into cabinet and connect it

to receptacle.

5. Plug the downdraft's power cord into the outlet.

WIRING D_AGRAM

UNE

ADJUSTMENT

The downdraft is factory-adjusted for proper operation. How-

ever, shipping and handling may affect the position of the

activating switch.

To adjust position of activating switch:

1. if downdraft is plugged into electrical outlet, unplug it.

2. Lift air vent straight up and cock it slightly so it remains in

the UP position.

WARNING: To avoid possible electrical shock,

personal injury or death - Disconnect etectri-

caJ power.

3. Remove switch cover from right end of air vent.

4. Loosen the 2 screws holding the switch bracket in place.

Position switch bracket so that activating switch just comes

in contact with underside of switch membrane. Tighten

screws.

5. Repiace switch cover, gently iower air vent into chimney,

and plug in power cord. Re-connect electricai power and

check operation.

_NSTALL COOKTOP

1. Align the cooktop with the downdraft and fasten cooktop

in place.

Accurate aBignment of cooktop and downdraft is neces-

sary to ensure that there is no interference when air vent

is raised and Ioweredo There should be a gap of 1/32"-1/16"

between the back of the cooktop and the front of the

downdraft cover.

COV&R

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Kenmore Elite 30'' Down Draft Hood 59960 Specifications Page 9

Comments to this Manuals