Kenmore Elite 30'' Down Draft Hood 59960 Specifications download pdf (Page 10)

WhentousetheRemoteUP/DOWNControJ

TheRemoteUP/DOWNControlshould be used when your

cooktop has a burner that is within 4 inches of the UP/DOWN

Button on the downdraft chimney.

The Remote UP/DOWN Control can be used for convenient

UP/DOWN operation of the downdraft chimney (even when a

burner is more than 4 inches from the UP/DOWN Button of the

downdraft chimney).

How to use the Remote UP/DOWN Contro!

Do net place the remote control where it wiII interfere with

cooking, where hot pans couId be set, or where hot liquids

could be spilled on the control.

The Remote UP/DOWN Control disables the UP/DOWN func-

tion of the UP/DOWN Button on the downdraft chimney.

Installation

1. Using the template at right, lay out the 3-hole pattern on the

counter top. Mark the centers of the three holes to be drilled.

2. Carefully drill the three holes through the counter top. Be

careful not to damage or chip the counter top surface when

drilling the holes.

3. Remove the control from the plastic bag. Line the control up

with the three holes and position the control so it is parallel

with the front of the counter top.

4. Remove the two nylon thumbnuts from the plastic bag and

thread onto the two studs on the control from below the

counter top. Hand tighten only.

WARNING: To reduce the risk of burns or ignition

of clothing by reaching across burners, the re-

mote control must be mounted at least 4" away

from any cook top burner.

5. Remove the blower, clamp channels, and gearmotor cover

from downdraft (see"Prepare the Downdraft" on page 5).

Remove the large panel to expose the downdraft's wiring.

6. At the lower right hand corner of downdraft, unplug the

cabIe from the left side of the wiring box.

7. Remove remote cable from the plastic bag and plug into back of

control from below counter top. Route cable through cabinet to

lower right hand corner of downdraft and through the clearance

holes in the side of downdraft and wiring box. Plug cable into

circuit board plug, as shown=

8. Stuff excess cable out of the way, secure the cable so it is not

damaged by items stored in the cabinet, and reassemble

downdraft.

2.000

.250 DIA.

HOLES

--f-

.750

CUT OUT ON DOTTED UNE

WIRING

BOX

LOWER

RIGHT

SIDE

DOWNDRAFT

CABINET

FLOOR

WIRING

BOX

REMOTE

CABLE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments

Kenmore Elite 30'' Down Draft Hood 59960 Specifications Page 10

Comments to this Manuals