Kenmore 625.347001 User Manual download pdf (Page 8)

-- STEP 5: INSTALL STORAGE TANK,

MAKE REMAINING TUBING CONNECTIONS --

1. CONNECT DRAIN TUBING, FAUCET TO

DRAINADAPTER:ReferringtoFIG.8,runtheloose

section (connected to faucet barb fitting) of black

3/8” tubingfromthefaucettothedrainadapter,with

a black collet, installed on page 6. Cut this tubing as

needed to route in as straight of a run as possible,

withoutloops,dips,lowspotsor kinks.Cuttheend

of the tubing square. Then, push allthe way intothe

fitting. Pull on the tubing to be sure it’s held firmly

in the adapter fitting.See pages 12 and13 fortubing

connection instructions.

2.CONNECTTUBINGTOWATERSUPPLY:Usethe

tubinginsert,ferruleandnuttofastenthe1/4” green

tubingtothesaddlevalvefitting installedonpage5.

Tighten the nut with a wrench.

3.MovethestoragetankintoplacenexttotheROas-

sembly. You can stand the tank upright, or lay it on

side. Apply no more than 2 wraps of Teflon tape to

thethreadsonthenippleatthetopofthetank.Hand

tighten, then wrench 1/4 turn only, the other in-

cluded tubing adapter fitting with the yellow collet

ontothetanknipple. BECAREFULNOTTOCROSS

THREAD.

4. Run the 3/8” yellow tubing to the fittinginstalled

in step 3. Be sure the end of the tubing is cut square,

and insert all the way intothe fitting.Again, pullon

the tubing to be sure it’s held firmly in the fitting.

water supply

valve

drain adapter

sink p---trap

RO product

water faucet

COLDHOT

3/8” black tubing, to

larger barb on faucet

TYPICAL UNDERSINK INSTALLATION

OPEN

insert

ferrule

nut

FIG. 8

yellow collet

tubing adaptor

Note: See note on page 4

regarding tubing lengths.

See note on

codes in the state

of Massachusetts,

page 5.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments

Kenmore 625.347001 User Manual Page 8

Comments to this Manuals

Related products and manuals for Water dispensers Kenmore 625.347001