Kenmore 625.347001 User Manual download pdf (Page 6)

-- STEP 2: INSTALL DRAIN ADAPTER --

J Note: Running the draintubing directly to afloor

drain, sump, standpipe, laundry tub, etc., as shown

on page 18, is preferred. However, if that is not pos-

sible or practical, the included drain adapterinstalls

in the sink drain pipe, always above or ahead ofthe

p-trap (FIG. 4). Be sure to comply with your local

plumbing codes. Other drain pipe fittings, in addi-

tion to the adapter, may be needed.

J The drain adapter fits 1-1/2” sink drain pipe.

J Theadapterinstallsdirectlyontothesinktailpiece

as typically shown in FIG. 4 and 5.

J Locatesodraintubingfromthefaucet(installedin

step 1, page 8) makes a straight run to the adapter,

without dips, loops, low spots or kinks.

Note: Consult a plumber if you are not familiar

with plumbing procedures.

1. Use aferrule and nutto assemblethe draintubing

connectortothedrainadapter(FIG.5).Turnthecon-

nectortoabout45_ fromthe12:00position,asshown

(to 10:00 or 2:00 position as needed). Tighten the nut

securely.

2. Carefully disassemble the sink drain pipe and

clean the tailpiece to assure a leak-tight fit.

3. Install the drain adapter onto the sink tailpiece,

using a ferrule and nut. Snug the nut, but do not

tighten.

Note: If needed, to make fit, you can cut toshorten

the unthreaded end of the adapter. Do not cut too

shortsotheadapterwillmakealeak-tightsealwith

the connecting fitting.

4.Assemblethep-traptothedrainadapter,andoth-

er drain pipe fittings as required (check codes) to

complete the drain run.

5.Tightenallconnections,butdonotovertightenand

break plastic fittings.

FIG. 4

A B

drain

adapter

45_

sink tailpiece

drain adapter

ferrule

nut

drain tubing

connector

FIG. 5

2:0010:00

45_

black

collet

cut, if

needed

-- STEP 3: INSTALL FAUCET --

A. PREPARE MOUNTING HOLE

1. Select 1 of the following places for the faucet. Be

sure it will fit flat against the surface, and there is

space underneath for tubing (see FIG. 8, page 8).

' Use an existing sink top hole for a spray hose or

other faucet. A 1” to 1-1/4” diameter hole is need-

ed.

' Drill a new hole in the countertop next to the

sink.

' Drill a new hole in the sink top.

CAUTION: To avoid damaging a sink beyond re-

pair, consult a qualified plumber or installer for

guides to drill holes in porcelain or stainless steel.

2. If drillingis needed,make the 1” to 1-1/4” diame-

ter hole.

3.Placeplumbersputtyaroundthedrilledhole(FIG.

6) to prevent water leakage around the base of the

faucet.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments

Kenmore 625.347001 User Manual Page 6

Comments to this Manuals

Related products and manuals for Water dispensers Kenmore 625.347001