Kenmore 350 series User Manual download pdf (Page 18)

SET PRESENT TIME OF DAY

If the words PRESENT TIME do not show in the display,

press the SELECT button until they do show in the display.

Press the UP or DOWN buttons to set the present time.

Press UP to move the display ahead; press DOWN to move

the time backward. If the present time is between noon and

midnight, be sure PM shows. If the present time is between

midnight and noon, be sure AM shows. Each press of the UP

or DOWN buttons changes the time by one (1) minute.

Holding the buttons in changes the time 32 minutes each

second.

SET WATER HARDNESS NUMBER

To set the water hardness number, complete the following

steps:

1. Press the SELECT button once to display 25 (flashing)

and HARDNESS. The grains per gallon (gpg) hardness of

your water supply is on your water analysis report. Be sure

to enter water test results on the Facts & Figure Chart on

page 3.

2. If your water supply contains iron, compensate for it by

adding to the water hardness number. For example,

assume your water is 20 gpg hard and contains 2 ppm

iron. Add 5 to the hardness number for each I ppm of iron.

In this example, you would use 30 for your hardness num-

ber.

2 ppm iron x 5 = 10

20 gpg hardness

+10

30 HARDNESS NUMBER

3. Press the UP or DOWN buttons to set your water hard-

ness number in the display. The DOWN button moves the

display to 1. The UP button moves the display to the high-

est setting (see maximum setting for your model in the

specifications).

NOTE: Each press of the UP or DOWN button changes

the display by 1 between 1 and 25. Between 25 and the

highest number, the display changes 5 at a time (25,

30, 35, etc.) Holding the UP or DOWN button in

changes the display twice each second.

SET REGENERATION TIME

To complete setting the regeneration time, complete the fol-

lowing steps:

1. Press the SELECT button to display 2:00 AM (flashing)

and RECHARGE TIME.

2. At the 2:00 AM recharge time setting, the softener begins

regeneration (see pages 26 - 28) at 2:00 AM. This is a

good time in most households because water is not being

used. If a different recharge time setting would be better

for your household, complete the following step.

PRESENT TIME

FIG. 26

Questions? Call The Kenmore Water Line 1-800-426-9345

Program The Timer

RECHARGE

TIME

HARDNESS

FIG. 27

3. Press the UP or DOWN buttons to set the desired

recharge starting hour. Be sure to observe the

AM-PM as you did when setting the present time

of day.

Note:

Note: Each press of the UP or DOWN buttons

changes the display one hour. Holding the but-

tons in changes the display twice each sec-

ond.

4. Press the SELECT button once again, to com-

plete initial programming, and the current time of

day shows in the display.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Comments to this Manuals

No comments

Kenmore 350 series User Manual Page 18

Comments to this Manuals

Related products and manuals for Water dispensers Kenmore 350 series