Kenmore 4908 User Manual download pdf (Page 24)

Wash any dirt or other material from the debris filter. Make

sure the drain pump propeller behind the debris filter is not

blocked.

6. Replace the debris filter cap.

7. Replace the filter cover.

S. Close up the opening of drain tube with cap.

9. Don’t insert the drain tube in the hole.

Replace inlet hoses after five years of use to reduce the risk

of hose failure. Periodically inspect and replace inlet hoses if

bulges, kinks, cuts, wear or leaks are found.

When replacing your inlet hoses, record the date of replacement.

Install and store your washer where it will not freeze. Because

some water may stay in the hoses, freezing can damage

your washer. If storing or moving your washer during freezing

weather, winterize it.

Non-use or vacation care:

Operate your washer only when you are at home. If you will be

on vacation or not using your washer for an extended period of

time, you should:

■ Unplug washer or disconnect power.

■ Turn off the water supply to the washer. This helps avoid

accidental flooding (due to a water pressure surge) while you

are away.

■ Slightly open door to provide ventilation.

1. Flush water pipes.

2. Reconnect water inlet hoses to faucets.

3. Turn on both water faucets.

To use washer again;

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

4. Plug in washer or reconnect power.

5. Run the washer through the Normal/Casual cycle. Use only

HE High Efficiency detergent. Use % the manufacturer’s

recommended amount for a medium sized load.

To transport the washer:

1. If washer will be moved during freezing weather, put in 1 qt (1

L) of R.V.-type antifreeze in the drum. Run washer on a Drain

& Spin cycle.

2. Unplug the power cord.

3. Disconnect the drain hose from the drain system and attach

to rear panel clips.

4. Shut off both water faucets.

5. Disconnect the water inlet hoses from faucets, then drain the

hoses and clip them to the rear panel of the washer.

6. IMPORTANT: Call service. Reinsert the shipping bolts to

minimize internal washer damage that may occur during

transportation. Upon completion of moving, please do not

forget to remove shipping bolts prior to installation, and keep

them for future use. Unit must be transported in the upright

position. To avoid suspension and structural damage, your

machine must be properly set up for relocation by a certified

technician.

Reinstalling the washer

To winterize washer;

1. Put 1 qt (1 L) of R .V.-type antifreeze in the drum.

2. Run washer on a Drain & Spin cycle.

3. Unplug washer or disconnect power.

4. Shut off both water faucets.

5. Disconnect water inlet hoses from faucets and drain.

1. Follow the “Installation Instructions” to locate, level and

connect the washer.

2. Run the washer through the Normal/Casual cycle to clean

the washer and remove the antifreeze, if used. Use only

HE High Efficiency detergent. Use 'A the manufacturer’s

recommended amount for a medium sized load.

(Best)Kemnore_592-49082-02883A-0 l_EN.indd 24 2011-03-23 ¿AAu 9:35:43

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments

Kenmore 4908 User Manual Page 24

Comments to this Manuals

Related products and manuals for Washers Kenmore 4908