Kenmore 110.4292 User Manual download pdf (Page 8)

Do not ground to a gas pipe.

Check with a qualified electrician if you are not sure the

washer is properly grounded.

Do not have a fuse in the neutral or ground circuit.

1. 3 prong grounding plug

2. 3 prong grounding-type

wall receptacle

3. Grounding prong

4. Power supply cord

GROUNDING INSTRUCTIONS

For a grounded, cord-connected washer:

This washer must be grounded. In the event of a

malfunction or breakdown, grounding will reduce the

risk of electrical shock by providing a path of least

resistance for electric current. This washer is

equipped with a cord having an equipment-grounding

conductor and a grounding plug. The plug must be

plugged into an appropriate outlet that is properly

installed and grounded in accordance with all local

codes and ordinances.

WARNING: Improper connection of the

equipment-grounding conductor can result in a risk of

electric shock. Check with a qualified electrician or

serviceman if you are in doubt as to whether the

appliance is properly grounded.

Do not modify the plug provided with the appliance -

if it will not fit the outlet, have a proper outlet installed

by a qualified electrician.

For a permanently connected washer:

This washer must be connected to a grounded metal,

permanent wiring system, or an equipment grounding

conductor must be run with the circuit conductors and

connected to the equipment-grounding terminal or

lead on the appliance.

INSTALLATION

INSTRUCTIONS

flernoh'^" ^ ■■.■/stBiii

AWARNING

Excessive Weight Hazard

Use two or more people to move and install

washer.

Failure to do so can result in back or other injury.

IMPORTANT: Position the washer so that the rear of the unit is

within approximately 3 ft (90 cm) of the final location.

There are 4 bolts in the rear panel of the washer that support the

suspension system during transportation. These bolts also retain

the power cord inside the washer until the bolts are removed.

«»

Using a 13 mm wrench, loosen each of the bolts.

Once the bolt is loose, move it to the center of the hole and

completely pull out the bolt, including the plastic spacer

covering the bolt. The power cord will be attached to all

4 bolts inside the washer.

3. Once all 4 bolts are removed, pull the power cord through the

opening of the rear panel and close the hole with the attached

cap.

4. Close the bolt holes with the 4 transport bolt hole plugs.

NOTE: If the washer is to be transported at a later date, call

your local service center. To prevent suspension and structural

damage, your machine must be properly set up for relocation

by a certified technician.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 67 68

Comments to this Manuals

No comments

Kenmore 110.4292 User Manual Page 8

Comments to this Manuals