Kenmore 95123 Installation Guide download pdf (Page 10)

4. Use a Phillips screwdriver to connect the green ground wire

from the power supply cord to the range with the ground-

link screw and ground-link section. The ground wire must be

attached over the ground-link section.

5. Use

" (1.0 cm) nut driver to connect the neutral (white)

wire to the center terminal block post with 1 of the 10-32

hex nuts.

6. Connect line 2 (red) and line 1 (black) wires to the outer

terminal block posts with 10-32 hex nuts.

7. Firmly tighten hex nuts.

NOTE: For power supply cord replacement, use only a

power cord rated at 250 volts minimum, 40 or 50 amps

that is marked for use with nominal 1

" (3.5 cm) diameter

connection opening, with ring terminals and marked for use

with ranges.

8. Tighten strain relief screws.

IMPORTANT: Verify the tightness of the hex nuts.

9. Replace lower access cover.

Install Using Direct Wire

Direct Wire Strain Relief

1. Disconnect power.

2. Remove the lower access cover screws located on the back

of the range. Pull the bottom of the cover toward you and

out to remove cover from range.

3. Remove plastic tag holding three 10-32 hex nuts from the

middle post of the terminal block.

A. 10-32 hex nut

B. Ground-link screw

C. Line 2 (red) wire

D. Green ground wire

E. Neutral (white) wire

F. Line 1 (black) wire

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Use 8 gauge copper or 6 gauge aluminum wire.

Electrically ground range.

Failure to follow these instructions can result in death,

fire, or electrical shock.

A. Mounting tabs (3)

B. Lower access cover

C. Screws (2)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comments to this Manuals

No comments

Kenmore 95123 Installation Guide Page 10

Comments to this Manuals