Kenmore 88963 User Manual download pdf (Page 31)

CONVECTION COOKING WITH AUTOMATIC PREHEAT

» I C n n

1 J u u

An Automatic preheating temperature of 350“ F for

convection cooking has been factory set into the oven.

(See step 3 below.)

1. Remove ceramic tray from

oven. Set the metal rack in

the desired cooking position;

upper or lower.

2. Touch CLEAR then touch CHE3

OVEN TEMP/PREHEAT. ( ■ sS" i

The light below COOK 1 wifl

go on and “F” shows in the

display window,

3. If you do not touch the

numbers for the oven

temperature, the oven starts

preheating to the 350® F uhen

START is touched.

If you want to preheat the

oven to the temperature other

than the 350® F, touch the

desired numbers For example,

to preheat the oven to 400°F.

touch 4,0 and 0. The“400F‘

will show in the display window,

4. Touch PAUSE. S

Light below COOK 2 will go

on and “0” shows in the

display window.

5. Touch CONVEC TME, [S

Lights above TIME and

CONVEC will go on and "0”

shows in the display window.

6. Set the convection cooking

time by touching the

corresponding numbers as

. Instructed in the Cookbook,

For example, set 45 minutes

by touching the numbers for

“4".'‘5'V'0”and'‘(r.Then

“4500" shows in the display

window, r~T~ir~5~ir~5~~ir‘o~l

NOTE: During convection

cooking, the oven keeps the

same temperature in second

stage as for preheating. If,

however, third stage is used, and

a temperature other than 350® F

is desired, the oven temperature

must be set in third stage.

7. Touch START, GED

The oven is working when the

oven light is on. Lights below

COOK 1, above PAUSE and

CONVEC will go on, and

“200F" is shown in the display

window.

As the oven temperature rises

above 200° F, the display

temperature increase in

10°Fsiep (210F, 220F, 230Fetc,}

'Rif

irsn

( 'll.« ÌI \

1 r

'ir"! 1

3 1

1 ♦

6 1

( 9 1

rSST'lf”»"! [ TSP

5 ilT*

9 W»

•jT

MTlmp.

When the temperature in the

oven reaches the preheat

temperature, "350F” or the

set temfjerature is displayed

and a pulsating beep tone will

sound to tell that the

preheating is over.

8, WARNING: The temperature in the oven is quite

high. Never touch the metal rack or oven wails with

bare hands. Open the door, the beep sound wii! stop

and the temperature display will change to “PAUS”.

Place the food inside the oven as quickly as possible.

While the door is open, the heated air will escape

from the oven and the oven temperature will drop.

. Touch START again .

The oven restarts, the oven

light and the lights below

COOK 2. above TIME and

CONVEC are on. The

"PAUS" display switches to

the time display. The time in

the display window counts

down.

A tone will sound and the

word “End” will show in the

display window for 2 seconds

when the 45 minutes are over.

Then the oven will automati

cally shut off.

NOTES: To display the

temperature of the oven

during cooking, touch OVEN

TEMP/PREHEAT,

After preheating is over, the beep tone will sound until

either the door is opened or 30 minutes have elapsed,

The oven temperature should be chosen in ten-degree

steps. For example, if a temperature of 325°F is

programmed, the oven will stop at the temperature

of 320° F.

Avoid opening the door often during cooking Hot

air will escape from the oven and the oven

temperature will drop very quickly, adversely

affecting the cooking results.

Use Pot holders to remove the Metal Rack after cook

ing as the Rack will be hot during cooking.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 50 51

Comments to this Manuals

No comments

Kenmore 88963 User Manual Page 31

Comments to this Manuals

Related products and manuals for Kiln Kenmore 88963