Kenmore 790. 4789 User Manual download pdf (Page 30)

General Care & Cleaning

Cleaning Various Parts of Your Oven

Before cleaning any part of the oven, be sure all controls are turned OFF and the oven is COOL. REMOVE SPILLOVERS

AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS NOW WILL REDUCE THE EXTENT AND

DIFFICULTY OF MAJOR CLEANING LATER.

Surfaces

How to Clean

Aluminum {Trim Pieces)

& Vinyl

Use hot, soapy water and a cloth. Dry with a clean cloth. Do not scour or use all

purpose cleaners, ammonia, powdered cleaners or commercial oven cleaner. They can

scratch and discolor aluminum.

Painted and Plastic,

Control Panel, Body Parts,

and DecorativeTrim

For general cleaning, use hot, soapy water and a cloth. For more difficult soils and

built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to

60 minutes. Rinse with a damp cloth and dry. DO NOT use abrasive cleaners on any

of these materials; they can scratch.

To remove control knobs, turn to the OFF position; grasp firmly and pull straight off

the shaft. To replace knobs after cleaning, line up the flat sides of both the knob and

the shaft; then push the knob into place.

Stainless Steel, Chrome,

Control Panel, Decorative

Trim

Before cleaning the control panel, turn all controls to OFF and remove the control

knobs. To remove, pull each knob straight off the shaft. Clean using hot, soapy water

and a dishcloth. Rinse with a clean water using a dishcloth. Be sure to squeeze

excess water from the cloth before wiping the panel; especially when wiping around

the controls. Excess water in or around the controls may cause damage to the

appliance.To replace knobs after cleaning, line up the flat sides of both the knob and

the shaft; then push the knob into place.

Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water

and a cloth. Do not use cleaners with high concentrations of chlorides or

chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are

especially made for cleaning stainless steel. Always be sure to rinse the cleaners

from the surface as bluish stains may occur during heating that cannot be removed.

Porcelain Enamel,

Broiler Pan and Insert,

Door Liner, Body Parts

Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1

solution of clear water and ammonia. If necessary, cover difficult spots with an

ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp

cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry with a clean

cloth. Remove all cleaners or the porcelain may become damaged during future

heating. DO NOT use spray oven cleaners on the cooktop.

Oven Racks

—

This oven comes with lubricated porcelain oven racks, which can remain in the oven

during the self-clean cycle. Do not clean this vegetable oil lubrication off the racks. It

is important that the sides of the oven racks always have a light coating of vegetable

oil. To maintain optimal rack performance, re-apply a thin layer of vegetable oil to the

sides of the rack after every self-clean cycle or when the rack becomes difficult to

slide.

Oven Door

NOT

Gasket

Use soap & water to thoroughly clean the top, sides and front of the oven door. Rinse

well. You may use a glass cleaner on the outside glass of the oven door. DO NOT

immerse the door in water. DO NOT spray or allow water or the glass cleaner to

enter the door vents. DO NOT use oven cleaners, cleaning powders or any harsh

abrasive cleaning materials on the outside of the oven door.

DO NOT clean the oven door gasket. The oven door gasket is made of a woven

material, on Self-Cleaning models, which is essential for a good seal. Care should be

taken not to rub, damage or remove this gasket.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Kenmore 790. 4789 User Manual Page 30

Comments to this Manuals

Related products and manuals for Kiln Kenmore 790. 4789