Kenmore ELITE 141.1668 User Manual download pdf (Page 15)

Fuel Gauge Display Installation.

IMPORTANT: Before installing batteries be sure the

gas tank is not mounted in the tank pull-out tray.

1. Open the front Doors of Cabinet. Pull out the LPG Tank

Pull-out Tray. Connect the Wire Plug "A” from Fuel

Gauge Display with the Wire Plug "B" from rear of Tank

Pull-out Tray. Unscrew 1/4" x 1/2” Phillips head Screw

from Rear Panel and install Wire Fastener to Rear

Panel. Tighten securely using the same screw. See

Fig.14a

2. From the underside of the Control Panel, unscrew the

Fuel Gauge Display Cover on the Fuel Gauge Display

Box. See Fig.14b

3. Carefully remove the battery box from the back of the

Fuel Gauge Display Box and insert two "AAA" batter

ies (provided). Be sure to follow correct polarity when

inserting batteries.

4. Return the Battery Box with electric wire into the Fuel

Gauge Display Box.

5. Screw the Fuel Gauge Display Cover onto the Fuel

Gauge Display Box.

Figure 14a

Fuel Gauge Display Operating - See Fig. 14c

Press the "CHECK" button to operate Fuel Gauge Display.

NOTE: Tank must be positioned in tray for Fuel

Gauge Display check

1. Fuel Display: Indicates gas tank fill level

2. Fuel Warning Display: When the gas tank fill level is

on the last row a warning signal will sound for approxi

mately 3 seconds to warn you that the tank volume is

near empty.

3. Battery Warning Display: A low battery warning light

will illuminate when the battery voltage drops to a low

level. Replace the batteries.

IMPORTANT: When the gas tank is removed from

the tank pull-out tray, the fuel gauge display will not

operate.

CHECK

BUTTON

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

No comments

Kenmore ELITE 141.1668 User Manual Page 15