Kenmore 46-73063 Owner's Manual Page 43

  • Download
  • Add to my manuals
  • Print
  • Page
    / 140
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 42
TROUBLESHOOTING
GUIDE
NOT
DISPENSING ICE
Check
if
...
Then •..
All
the
doors
are
not
closed completely. Ice will not dispense
if
any of the refrigerator doors are left
open.
The dispenser
display
is
locked. Press and hold the Lock ( I
==-
I ) for 3 seconds
to
unlock the
control panel and dispenser.
Ice
is
not
selected
on
the
dispenser. The dispenser can be set for ice
or
water. Make certain that
the
control panel is set for
the
proper operation. Press the
dispenser button
on
the control panel to cycle through the ice
and water options.
The ice dispenser
is
not
used often. Infrequent use of the ice dispenser will cause the cubes to
stick together over time, which
will prevent them from properly
dispensing. Check the ice bin for ice cubes clumping/sticking
together.
If they are, break up the ice cubes
to
allow for proper
operation.
Ice
bin
is
not
installed correctly. Be sure
to
install the ice bin firmly into position.
New
installation.
Wait 24 hours after ice maker installation for ice production to
begin. Wait
72
hours for full ice production.
Ice cubes are
stuck
in
the
delivery chute. Use a plastic utensil to clear the delivery chute.
The ice dispenser
is
stalling
while
dispensing Change the ice button from "crushed"
to
"cubed".
"crushed"
Ice. If cubed ice dispenses correctly, depress the button for
"crushed" ice and begin dispensing again.
DISPENSING WARM WATER
Check
If
...
Then •..
New
installation.
Allow 24 hours after installation for the water supply to cool
completely.
The
water
dispenser
has
been
recently
used.
The unit has its own water tank inside. The water storage
capacity is
12
oz. (345 ml) of cold water.
The
refrigerator
is
connected
to
a
hot
water
line. Make sure the refrigerator is connected to a cold water pipe.
43
Page view 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 139 140

Comments to this Manuals

No comments