Kenmore 26 cu.ft. Capacity Side-by-Side Refrigerator w/ Grab-N-Go Door Owner's Manual download pdf (Page 14)

REFRIGERATOR INSTALLATION

Left leveling

leg

Height

difference

PRESS & HOLD

CHANGE FILTER

Right leveling leg

Height

difference

Height

difference

PRESS & HOLD

CHANGE FILTER

Height

difference

Height

difference

PRESS & HOLD

CHANGE FILTER

Down

keeper nut

Adjustment

hinge pin

Tool for

adjustment

LEVELING

After installing, plug the refrigerator’s power cord into a

3-prong grounded outlet and push the refrigerator into the

ﬁ nal position.

Your refrigerator has two front leveling legs—one on the

right and one on the left. Adjust the legs to alter the tilt

from front-to-back or side-to-side. If your refrigerator

seems unsteady, or you want the doors to close more

easily, adjust the refrigerator’s tilt using the instructions

below:

NOTE: Tools Required: 11/16” (18mm) wrench or ﬂ at blade

screwdriver.

1. Turn the leveling leg counterclockwise to raise that side

of the refrigerator or clockwise to lower it. It may take

several turns of the leveling leg to adjust the tilt of the

refrigerator.

NOTE: Having someone push backward against the top of

the refrigerator takes some weight oﬀ of the leveling legs.

This makes it easier to adjust the legs.

2. Open both doors again and check to make sure that

they close easily. If the doors do not close easily, tilt

the refrigerator slightly more to the rear by turning

both leveling legs counterclockwise. It may take

several more turns, and you should turn both leveling

legs the same amount.

DOOR ALIGNMENT

If the doors are still uneven after the refrigerator has

been leveled, ﬁ nish adjusting the doors by following the

instructions below.

Adjusting tools: 5/16” (8mm) wrench and 3/4” (19mm)

wrench

Using a 3/4” (19mm) wrench, turn the keeper nut

clockwise to loosen the keeper nut.

Using a 5/16” (8mm) wrench, turn the adjustment hinge

pin clockwise or counterclockwise to level the refrigerator

and freezer door.

After leveling the door, turn the keeper nut

counterclockwise to tighten it.

CAUTION: Do not overtighten the door adjustment

screw. The hinge pin can be pulled out. (The adjustable

range of height is a maximum of 2” [5 cm]).

The height of the freezer door can also be adjusted by

inserting a maximum of three snap rings (two rings are

included with this owner’s manual). To insert, open the

freezer door and lift it at the lower hinge. Use a pliers to

insert the ring on the lower hinge pin.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 85 86

Comments to this Manuals

No comments

Kenmore 26 cu.ft. Capacity Side-by-Side Refrigerator w/ Grab-N-Go Door Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Fridges Kenmore 26 cu.ft. Capacity Side-by-Side Refrigerator w/ Grab-N-Go Door