Kenmore 233.503632 User Manual download pdf (Page 3)

INSTALL BACKSPLASH (OPTIONAL)

If optional backsplash is used, attach it to the

finished wall. Secure hood mounting bracket

to the backsplash and omit wall framing

described below.

INSTALL THE DUCTWORK

NOTE: To reduce the risk of fire, use only

metal ductwork.

run1. Decide where the ductwork will

between the hood and the outside.

2. A straight, short duct run will allow the hood

to perform most efficiently.

3. Long duct runs, elbows, and transitions will

reduce the performance of the hood. Use

as few of them as possible.

4. Install a roof or wall cap. Connect 6" round

metal ductwork to cap and work back to

wards hood location. Use duct tape to seal

the joints between ductwork sections.

INSTALL MOUNTING

BRACKET

1. Construct wood wall framing that is flush

with interior surface of wail studs.

Make sure:

a) the framing Is centered over installation location.

b) the height of the framing will allow the mounting bracket to be secured to the

framing within the dimensions shown.

After wall surface is finished, secure mounting bracket to framing using dimensions

shown.

INSTALL THE HOOD

1. Hang the hood from the bracket through the rectangular cut-out on the back of

the hood. Cut-out is

larger than the bracket to

allow for horizontal

adjustment. The bottom of

the hood should be 24"

to 30" above the cooking

surface.

2. Height adjustment

screws provide vertical

adjustment.

3. Secure the hood with

additional mounting

screws. Use drywall

anchors, provided, if wall

studs or framing are not

available.

1 2 3 4 5 6 7 8 ... 19 20

Comments to this Manuals

No comments

Kenmore 233.503632 User Manual Page 3

Comments to this Manuals

Related products and manuals for Fans Kenmore 233.503632