Kenmore 580.75116 User Manual download pdf (Page 8)

INSTALLATION

Cl Redirect the louvers at the back of the wall

** sleeve to 60° angle as shown in the FIG 9. The

use of pliers is recommended.

procedure b

60"

7 3/32“

v\\\\\\\\\\\\\\\\\\\l///////////

Rear Louvers

(Top View)

^0"

FIG. 9.

if the wall sleeve already has a rear grille, skip

to step 4. if the wall sleeve does not have a rear

grille or louvered panel, install the plastic grille

from the kit. Cut the plastic grille to 25-1/2" wide

and 15-1/4" high. Place the plastic grille to the

inside of the wall sleeve at the rear flange.

Fasten the 4 washer screws to secure the grille

to the wall sleeve. If you need plastic nuts to

mount plastic grille to the Inside of the wall

sleeve, there are plastic nuts in the installation

kit. The nuts are installed from the Inside of the

sleeve and are pressed into the square holes of

the rear flanges.

Fasten the screws

Remove the backing from the Vertical Insulation

strip 159/16 X 13/g X 13/8 and attach that to the

inside right of the sleeve as shown below.

Remove the backing from the Around Insulation

strip 671/e X 13/g X 25/32 and attach that to the

inside front of the sleeve as shown below.

Indoor Outdoor

91/3“ 6"

FIG. 12

Remove the metal rear grille and replace it with

the plastic rear grille to improve unit energy

efficiency. The plastic grille reduces the amount

of hot air discharge that recirculates through the

unit.

if the depth of your existing wall sleeve is less

than or equal to 18“, skip to step 7. Otherwise,

cut the baffles and the support blocks according

to length "A“ in the table below.

Depth'D" of the existing

wall sleeve (inches)

Length "A"

(inches)

18 <0^18-%

3/4

la-Va <D<19-%

1-3/4

19-3/4 <D<22

[

- Support

Block

— Baffle

^ FIG- 14

FIG. 11

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Comments to this Manuals

No comments

Kenmore 580.75116 User Manual Page 8

Comments to this Manuals

Related products and manuals for Conditioners Kenmore 580.75116