Kenmore Stainless Steel 4 Burner Gas Grill with Oven Owner's Manual download pdf (Page 13)

464225913 • 13

Figure D

Side burner Ignitor Lighting

Do not lean over grill while lighting.

1. Open side burner lid. Turn ON gas at LP cylinder.

2. Turn side burner knob to the HI position, push and hold

ELECTRONIC IGNITOR button.

3. If side burner does NOT light within 5 seconds, turn knob

to OFF, wait 5 minutes, then repeat lighting procedure.

Match lighting the Side Burner - Figure D

1. Open the side burner lid during lighting.

2. Place match in match holder. Strike the Match. Position

lit match close to the side burner.

3. Push in and turn side burner knob to position. Be sure

burner lights and stays lit.

4. If ignition does NOT occur in 5 seconds, turn the burner

control knob OFF, wait 5 minutes for gas to clear away,

and repeat the lighting procedure.

Outdoor Oven Ignitor Lighting

Do not lean over grill while lighting.

1. Open Oven lid. Turn ON gas at LP cylinder.

2. Turn Oven knob to the position, push and hold

ELECTRONIC IGNITION button.

3. If oven burner does NOT light within 5 seconds, turn knob to

OFF, wait 5 minutes, then

Outdoor Oven Match Lighting

1. Open Oven lid. Turn ON

3. Turn oven knob to the position.

Be sure burner lights and stays lit.

gas at LP cylinder.

repeat lighting procedure.

2. Place match into match holder

(hanging from side panel of grill).

Light match; then light burner by

placing match through the match

light hole on left side of oven.

HIGH

LOW

General Grill Cleaning

• Do not mistake brown or black accumulation of grease

and smoke for paint. Interiors of gas grills are not

painted at the factory (and should never be painted).

Apply a strong solution of detergent and water or use a

grill cleaner with scrub brush on insides of grill lid and

bottom. Rinse and allow to completely air dry. Do not

apply a caustic grill/oven cleaner to painted or glass

surfaces.

• Plastic parts: Wash with warm soapy water and wipe

dry.Do not use citrisol, abrasive cleaners, degreasers or a

concentrated grill cleaner on plastic parts. Damage to

and failure of parts can result.

• Porcelain surfaces: Because of glass-like composition,

most residue can be wiped away with baking

soda/water solution or specially formulated cleaner. Use

nonabrasive scouring powder for stubborn stains.

• Painted surfaces: Wash with mild detergent or

nonabrasive cleaner and warm soapy water. Wipe dry

with a soft nonabrasive cloth.

• Stainless steel surfaces: To maintain your grill’s high

quality appearance, wash with mild detergent and warm

soapy water and wipe dry with a soft cloth after each

use. Baked-on grease deposits may require the use of an

abrasive plastic cleaning pad. Use only in direction of

brushed finish to avoid damage. Do not use abrasive

pad on areas with graphics.

• Cooking surfaces: If a bristle brush is used to clean any

of the grill cooking surfaces, ensure no loose bristles

remain on cooking surfaces prior to grilling. It is not

recommended to clean cooking surfaces while grill is hot.

Burner Flame Check

• Remove cooking grates and flame tamers. Light burners,

rotate knobs from HIGH to low. You should see a

smaller flame in low position than seen on HIGH

Perform burner flame check on side burner, searing

burner and rotisserie also. Always check flame prior to

each use. If only low flame is seen refer to "Sudden drop

or low flame" in the Troubleshooting Section.

Turning Grill Off

• Turn all knobs to OFF position. Turn LP cylinder off by

turning hand-wheel clockwise to a full stop.

Ignitor Check

• Turn gas off at LP cylinder. Push and turn control knob

to and hold in. You will hear a clicking sound as the

burner is being ignited. Ignition should occur within 5

seconds, but continue to hold the knob in for a full 10

seconds to maintain ignition.

Valve Check

• Important: Make sure gas is off at LP cylinder before

checking valves. Knobs lock in OFF position. To check

valves, first push in knobs and release, knobs should

spring back. If knobs do not spring back, replace valve

assembly before using grill. Turn knobs to LOW position

then turn back to OFF position. Valves should turn

smoothly.

Hose Check

• Before each use, check to see if hoses are cut or worn.

Replace damaged hoses before using grill. Use only

valve/hose/regulator specified by manufacturer.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Comments to this Manuals

No comments

Kenmore Stainless Steel 4 Burner Gas Grill with Oven Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Barbecues & grills Kenmore Stainless Steel 4 Burner Gas Grill with Oven