1Use & Care GuideModel No.153.321160 60 Gallon 153.321180 80 GallonKenmore® EliteHybrid Electric Water HeaterFor potable water heating only.No
10 Water Piping System Piping, fi ttings, and valves should be installed according to the installa
118. After piping has been properly connected to the water heater, open the nearest hot water faucet. Then open the cold water shut off valve and all
12Temperature-Pressure Relief Valve
13Filling the Water Heater Never use this water heater unless it is completely full of water. To prevent damage to
148. Connect the electrical supply to the water heater. NOTE: Remove the standard 1/2 inch knock-out (opening) in the junction box for conduit conn
15Water Heater Location □ Centrally located with the water piping system. □ The fl ooring beneath the water heater must be able to sup
16Before Using 1. Make sure the water heater has been properly
17Operating Mode Descriptions The operating modes can be changed by touching the desired mode icon on the User Interface Module (see F
18If after manually operating the valve, it fails to completely reset and continues to release water, immediately close the cold water inlet to the wa
191. Press the power button on the user interface module to place the water heater in Standby Mode.2. Turn off the power to the water heater.FIGURE
2SAFE INSTALLATION, USE AND SERVICEYour safety and the safety of others is extremely important in the installation, use and servicing of this water he
202. Remove (slide) the filter from the unit.3. If you are replacing the filter skip to step 4. To clean the filter use a vacuum with a hose attachm
21TROUBLESHOOTINGStart Up Conditions THERMAL EXPANSIONAs water is heated, it expands (thermal expansion). In a closed system, the volume of wat
22“AIR” IN HOT WATER FAUCETSHYDROGEN GAS: Hydrogen gas can be produced in a hot water system that has not been used for a long period of time (general
23DISPLAY SHOWS INDICATES CORRECTIVE ACTIONUPPER ELEMENT CONNECT FAULT1. Upper element is not functioning1. Turn off power at the circuit breaker/fu
24TROUBLESHOOTING CHARTPROBLEM POSSIBLE CAUSE(S) CORRECTIVE ACTIONNO HOT WATER 1. No power to the water heater (power button not lit)2. Unit in stan
25LEAKAGE CHECKPOINTSRead this manual fi rst. Then before checking the water heater make sure the electric supply has been turned “OFF”, and never turn
26Now that you have purchased this water heater, should a need ever exist for repair parts or service, simply contact any Sears Service Center or call
27NOTES
28® Registered Trademark / TM Trademark of KCD IP, LLC in the United States, or Sears Brands, LLC in other countries ® Marca Registrada / TM Marca de
3GENERAL SAFETY
410 - YEAR LIMITED WARRANTY ON WATER HEATERFor ten years from the date of purchase, if this water heater is installed and operated in a single-family
5SAFE INSTALLATION, USE AND SERVICE...
6Thank You for purchasing a Sears water heater. Properly installed and maintained, it should give you years of trouble free service. It is strongly su
7MATERIALS AND BASIC TOOLS NEEDEDBasic ToolsYou may or may not need all of these tools, depending on your type of installation. These tools can be pur
8Removing the Old Water Heater FIGURE 2.1. Turn “OFF” electrical supply to the water heater.FIGURE 3.2. Open a nearby hot water
9Mineral buildup or sediment may have accumulated in the old water heater. This causes the water heater to be much heavier than normal and this residu
Comments to this Manuals