Kenmore 625.3882 User Manual download pdf (Page 22)

f J J J J ,i J J J J J ,i J J J J J ,i J J J J J

IJJJ J J J J J J J J J J J J J J J J J J J J

SECTION 5

tjjj ,i J J J J J ,i J J J J J ,i J J J J J ,i J

J J J J J J J J J J J J J J J J J J J J J J J

SERVICE TECH. INFORMATION

A. jrouBLESHOOTING

ij.jjjj.jj.jjjj.jj.jjjj

ijjj jj^jj J jjjjj J J

IJJ.^^^SjJ J JJJJJ J J

ijjJVSSjj J jjjjj J J

IJjSduBjJ J JJJJJ J J

ijjjJjjjjjJjjjjjJJ

rjj^jj^jjjj^jj^jjjj^jj^j

UJJJJJJJJJJJJJJJJ

WIRING SCHEMATIC BACK OF TIMER

(PWA)

24VAC

Transformer

'UT POS'TURBINE MOTOR

h Mill

Turbine

Sensor

GNC

“T

valve

motor

,NC Position

Switch

Keep this manual with your water softener. If repairs are needed, the service technician must have

the information on the following 8 pages. For telephone assistance, call toll free, 1-800-426-9345.

ALWAYS MAKE THESE INITIAL CHECKS FIRST

Does the time display show the correct time of

day?

- - If display is blank, check power source to the

softener.

--If time is flashing, power was off for over 24

hours. The softener resumes normal operation

but regenerations occur at the wrong time.

- - If an error code (Example: Err3) shows in the

faceplate display, go to AUTOMATIC ELEC

TRONIC DIAGNOSTICS, page 5-2.

Plumbing bypass valve(s) must be fully in ser

vice position.

The inlet and outlet pipes must connect to the

softener inlet and outlet respectively.

Is the transformer plugged into a "live",

grounded wall outlet, and the power cable fas

tened securely?

The valve drain hose must be free of kinks and

sharp bends, and not elevated over 8 ft. above the

floor.

^Remove the top cover and salt tank cover.

Is there salt in the storage tank?

Is the brine tubing connected? Brine tubing con

nects to nozzle venturi and brine valve assembly.

(See page 6-3, key #83)

3 Is the brine valve float set right? (See page 5-4).

3 Press the SELECT button two times to display

the hardness setting. Be sure it is the correct set

ting for the household's water supply. (Make a

hardness test of the raw water and compare with

the hardness setting. Also test a soft water sam

ple to verify if a problem exists.) Press the SE

LECT button twice more to return to present time

in the display.

If you do not find the problem after making initial

checks, do the MANUAL INITIATED ELEC

TRONIC DIAGNOSTICS, and the MANUAL AD

VANCE REGENERATION CHECK.

5 - 1

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Comments to this Manuals

No comments

Kenmore 625.3882 User Manual Page 22

Comments to this Manuals

Related products and manuals for Water equipment Kenmore 625.3882