Kenmore 153.331492 User Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
OPERATING YOUR WATER HEATER
Lighting Instructions
Read and understand these directions thoroughly before
attempting to light or re-light the pilot. Make sure the view port
is not missing or damaged. (See Figure 33.) Make sure the
tank is completely filled with water before lighting the pilot.
Check the rating plate near the gas control valve/thermostat for
the correct gas. Do not use this water heater with any gas other
than the one listed on the rating plate. If you have any questions
or doubts, consult your gas supplier or gas utility company.
U/
AWARNING
Explosion Hazard
Replace view port if glass is missing
or damaged.
Failure to do so can result in death,
explosion or fire.
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
a:
BEFORE LIGHTING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES
A. This appliance has a pilot which is lit by a piezo- *lf you cannot reach your gas supplier, call the fire
electric spark gas ignition system. Do not open department
the inner door of the appliance and tryTo light
the pilot by hand. C.Use only your hand to push in or turn the gas control
B. BEFORE LIGHTING smell all around the appliance knob. Never use tools. If the knob will not push In or
area for gas. Be sure to smell next to the floor turn by hand, don't try to repair it, call a qualified
because some gas is heavier than air and will service technician. Force or attempted repair may
settle on the floor. result in a fire or explosion.
WHAT TO DO IF YOU SMELL GAS ^ qq use this appliance if any part has been under
Do not try to light any appliance. water. Immediately contact a qualified Installer or
• Do not touch any electric switch; do not use any ^ jo replace a flooded water heater,
phone in your building.
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
Do not attempt to repair the unit! It must be replaced!
LIGHTING INSTRUCTIONS
MAIN BURNER-
JHERIOPILE
1.
GAB UUI
FIGURE'D'
STOP! Read the safety information
above on this label.
2. Turn gas control knob fully counterclockwise
*:) to "OFF". SEE FIGURE 'A'.
3. Remove the outer burner door located below
the gas control.
4. Wait five (5) minutes to clear out any gas. If you
then smell gas //^%STOP! Follow "B" in the
safety informationf »1 above on this label. If
you don't smell gas,\Er go to next step.
5. This unit is equipped with a push button pilot ignitor,
which is used to light the pilot. Locate the ignitor
on the gas control.
6. Turn gas control knob clockwise
rto "PILOT” . SEE FIGURE 'B'.
7. The pilot is located on the left side of the burner. It
can be located by looking through the glass view port
while pressing the piezo ignitor button several times.
Look for a spark at the pilot location, Figure 'D'.
8. Once the pilot has been found, push the gas control
knob all the way in (toward the water heater.) Immediately
10.
press the piezo ignitor button rapidly (4) or(5) times.
If the pilot will not light, repeated steps (2) through (8).
Continue to hold the gas control knob in for about
(30) seconds after the pilot is lit until the status L.E.D.
is flashing (one flash every three seconds is normal.)
Release the gas control knob and the pilot should
remain lit. If it goes out, repeat steps (2) through (8).
It may take several minutes for air to olear the lines
before the pilot will light.
»If the pilot will not stay lit after several tries,
turn the gas control knob counterclockwise "D
to "OFF" and call your service technician or gas
supplier. SEE FIGURE 'A'.
Once the pilot flame is established replace the
outer burner door.
At arm's length away, turn gas control
knob clockwise C to desired temperature setting.
SEE FIGURE 'C.
DANGER: Hotter water increases the risk
of scald injury. Consult the instruction
manual before changing temperature.
.
.............
TO
.
TURN
..
OFF
..
GAS
..
TO
.
APPLIANCE
....
I.Turn control/thermostat knob fully counterclockwise to "OFF".
SEE FIGURE 'A'.
22
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Comments to this Manuals

No comments