Kenmore 417-41942H User Manual download pdf (Page 20)

Performing Manual Drain

Cleaning Pump Filter

Care and Cleaning

Inspect for O-ring before

reinserting pump lter

In the event the washer will not drain under its own power

due to a power outage or clogged drain pump you can

drain the water left in the drum manually.

With the wash tub and drain hose drained of all water and

the drain spout snapped in place, follow these directions to

remove, clean, and reinsert the pump lter.

1. “Unscrew” the lter and pull it out.

2. Dump foreign contents from the lter tray and inspect

the opening for any loose objects.

3. Rinse the lter completely before putting it back in

place.

NOTE

Removing the pump cleanout door completely may be

necessary to place your catch pan under the drain spout.

NOTE

You may have to add about 2 quarts of clean water

through the mainwash detergent compartment to reprime

the drain pump.

With a catch pan ready, pinch the two aps on the sides

drain spout and ip it down.

4. “Screw” lter back in place until it stops. The arrow on

the drain spout should be pointing upward.

5. Reinstall pump cleanout door if removed earlier.

IMPORTANT

Check to make sure O-ring is in place before reinserting

pump lter. Take care to not cross threads when turning

pump lter during reinsertion.

CAUTION

BURN HAZARD

Do not attempt to manually drain the drum if it is full of

hot water. Allow water to cool before proceeding with

manual draining.

When the water has stopped owing, press the drain spout

back up and in until the outer aps snap into place.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

No comments

Kenmore 417-41942H User Manual Page 20