Kenmore Automatic Washers User Manual download pdf (Page 14)

C. CONNECT DRAIN HOSE

for your Benefit

Proper connection of the drain hose

will protect your floors from damage

due to water leakage.

STEP 1. To prevent the drain hose from

corning off or leaking, it must be installed

per the following instructions;

IMPORTANT: To ensure proper installa

tion, this procedure must be followed

exactly.

a. Wet the inside of the straight end of

the drain hose with tap water. DO

NOT USE ANY OTHER LUBRICANT.

b. Squeeze ears of silver, double-wire

clamp with pliers to open. Place clamp

over the straight end of the drain hose

'/4 inch from the end.

c. Open clamp. Twist hose back and

forth while pushing down onto drain

connector at the bottom of the washer.

Continue until hose contacts the

ribbed stop on the cabinet.

d. Place clamp over area marked

“CLAMP.” Release clamp.

If you have:

You will need to buy:

Drain hose that is too short

Drain hose, Part No. 388423 and

hose kit, Part No. 285442

Drain hose that is too long

Hose kit, Part No. 285442

A problem with lint clogging your drain

Drain protector, Part No. 367031

Parts listed are available from your local Sears store or Sears Service Center.

Call 1-800-366-PART (1-800-366-7278).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

No comments

Kenmore Automatic Washers User Manual Page 14