Kenmore 790. 9021 User Manual download pdf (Page 24)

Before You Call ® Solutions to common problems

Problem

Oven smokes excessively v/hen broiling.

Solution

• Incorrect setting. Follow broiling instructions in Setting Oven Controls

section.

• Be sure oven door is opened to broil stop position when broiling.

• Meat too close to the broil element. Reposition the broil rack to provide

proper clearance between the meat & the element. Preheat the broil

element for searing.

• Meat not properly prepared. Remove excess fat from meat. Cut remaining

fatty edges to prevent curling, but do not cut into lean.

• Grease has built up on oven surfaces. Regular cleaning is necessary when

broiling frequently. Old grease or food spatters cause excessive smoking.

Flames inside oven or smoking from oven

vent.

Excessive spillovers in oven. For example this will happen for pie

spillovers or large amounts of grease left on the oven bottom. Wipe up

excessive spillovers before starting oven. If flames or excessive smoke

are present see

Broil in Setting Oven Controls section.

Oven control panel beeps & displays

any F code error.

Oven control has detected a fault or error condition. Press stop key pad to

clear the error code. Try Bake or Broil function. If the F code error repeats,

remove power from appliance, wait 5 minutes and then repower appliance

and set clock with the correct time of day. Try Bake or Broil function again.

If the fault recurs, press stop to clear and call 1-800-4-MY-HOME® for

assistance (See back cover).

Select Clean does not work. • Oven control not set properly. Review instructions in Select Clean section.

Soil not completely removed after

running Select Clean cycle.

Select Clean was interrupted. See Select Clean instructions.

Excessive spillovers on oven bottom. Remove before starting Select Clean.

Failure to clean soil from the oven frame, the door liner outside the oven

door gasket and the small area at the front center of the oven bottom.

These areas are not in the self-cleaning area, but get hot enough to burn

on residue. Clean these areas before the self-cleaning cycle is started.

Burned-on residue can be cleaned with a stiff nylon brush and water or a

nylon scrubber. Be careful not to damage the oven gasket.

Oven racks discolored.

Oven racks left in oven cavity during Select Clean. Always remove oven

racks from oven cavity before starting a self-clean cycle. Clean by using a

mild, abrasive cleaner following manufacturer's instructions. Rinse with clean

water, dry and replace in oven.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Kenmore 790. 9021 User Manual Page 24

Comments to this Manuals

Related products and manuals for Radio Kenmore 790. 9021