Kenmore 141.178600 User Manual download pdf (Page 11)

Attach the Pressure Cylinder Holder and Tank

Guide to the Cart Legs-Wheel Side of grill as

shown in Fig. 6 Align the tapped holes of both

parts with the holes on Side Panel. Secure firmly

using 4 of the 1/4"x1/2" Phillips head screws and

nuts provided.

Assembling The Grill Pulled-out Spice Tray

1. Install 2 of the 1/4''x1/2" Phillips head screws

to the rear of the Track. Without these screws

the Pulled-out Spice Tray will not stop properly.

2. Slide the Pulled-out Spice Tray into the Tracks

until it stops. See Fig. 7.

3. Install 2 of the 1/4''x1/2" Phillips head screws

to the front of the Track. This important step

prevents the Pulled-out Spioe Tray from being

pulled outside the tracks. See Fig. 7.

Assembling The LP Gas Tank Hook

Installing The Grill Head

1. Now that you've assembled the grill oart you

can install the pre-assembled Grill Head. See

Fig. 8 To reduce the weight of the Grill

Head, we suggest you open the Grill Lid and

remove the packed components. Even with

the components removed, this step requires 2

people to lift and position the Grill Head onto

the grill cart. Be sure to align the 2 holes

beneath the hang ledge on each side of the

Grill Head with the 2 holes on each cross

brace of cart. Raise Grill Lid and insert 4 of

the 1/4"x1-3/8" Phillips head screws and lock

nuts and tighten securely.

2. From the back side of grill head, install the

Grease Draining Tray. See Fig. 8.

3 Center the Grease Receptacle under Grease

Draining Tray, See Fig. 8.

4. Install Rear Wind Shield between both Bowl

Side Panels by using 2 of the 1/4"x1/2"

Phillips head screws provided. See drawing

below.

Figure 6

Figure 7

Figure 8

GREASE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

No comments

Kenmore 141.178600 User Manual Page 11