Kenmore 17568563 User Manual download pdf (Page 5)

LET’S KEEP GOING.. .IT’S GETTING EASIER, WE HOPE.

NOW WE’RE GETTING INTO

THE ACTUAL INSTALLATION.

SEPARATE THE PARTS IN

THE MOUNTING ASSEMBLY.

First, remove the mounting assembiy

from the iower mounting ring. Holding

the mounting assembly with one hand,

insert your wrenchette or screwdriver

into one of the lugs ol the tower moun

ting ring and turn it to the left

(counterclockwise) with your other

hand.

Then loosen the screws on the moun

ting assembly until they are just level

with the surface ol the mounting ring,

Mounting Ririg / J

Snap /

Groove

Sirie Sleeve

Mrxmlinn

D. 1 K.—

Now, use a screwdriver to pry off the

snap ring.

The assembly will now come apart. Set

it aside and move to the next step.

NEXT, LET’S ATTACH THE

UPPER MOUNTING

ASSEMBLY.

First, worldng from under the sink, slip the

fiber gasket and next the metai back-up

ring (flat side up) up and over the sink

sieeve.

Hold the fiber gasket and metal back- up

ring In place with one hand and place

the mounting ring with its three screws onto

the sink sieeve.

Now. push the fiber gasket, metal back-up

ring and the mounling mg further up on the

sink sleeve. Side the snap ring onto the sink

sleeve until it pops into place iri the groove

on the sleeve.

Tighten the three mounting screws with

your screwdriver until the whole mounting

^sembly Is seated evenly and tightly

against the sink.

APPLY PUTTY TO THE

SINK SLEEVE.

Make a fat snake ol “plumber’s"

putty by rolling it between your

hands.

Apply this roil under the rim of the

sink sleeve.

Then, place the sink sleeve into the

sink drain hole and push down

gently bul firmly to make sure it sits

eveniy in the putty.

TURN YOUR NEW

iVg n DISPOSER UPSIDE

■m M DOWN AND REMOVE

■ THE ELECTRICAL

PLATE FROM THE DISPOSER SO

YOU CAN SEE THE WIRING AND

THE GROUND SCREW. THE BOTTOM

OF YOUR DISPOSER WILL LOOK

LIKE THE ONES SHOWN IN ‘A’ OR ‘B’.

(Star! here if you are replacing a disposer with the same mounting.)

Remove the electrical piale from the bottom of the disposer and puil out the

black and white electrical wires. The green ground screw is also under this

píate.

GREEN GROUND

RESET SCB|

Bl/TTCW

BLACK AND

WHiTE WfRES

BUJLT-(N

CABLE CLAWP

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Kenmore 17568563 User Manual Page 5

Comments to this Manuals

Related products and manuals for Kitchen Kenmore 17568563