Kenmore ELITE 141.16681 User Manual download pdf (Page 11)

Electrode Check ~ Requires an Assistant

Before placing the cooking components into your

grill, ensure that the Spark Electrode Tip is properly

poationed within each Gas Collector Box ( a 4"

vwde stainless mechanism found at the front be

tween each set of Burners.) The easiest way to

enajre this is to perform this Electrode Check:

1. Be sure all Control Knobs are set to

and open the Grill Lid.

"OFF"

2. Have an assistant stand behind to the right of

the grill and look down at each Gas Collector

Box. NEVER put your face inside Grill Head.

3. Press the Ignitor Cap. You should hear a

"clicking" sound and your assistant should see

a small blue spark within each Gas Collector

Box. If a spark is present the Electrode Tips

are properly positioned.

4. if no spark is seen the Spark Gap shown in

Figure 4 needs to be adjusted as follows:

• Using an adjustable wrench, loosen the inside

Nut just until the Gas Collector Box can be

maneuvered and turned upward.

• The gap between the Spark Electrode Tip and

Spark receiver should be approximately 3/16".

* if the gap is wider than 3/16" use a pai r of long

nose pliers and gently squeeze the Gas Collector

Box until the gap is correct.

• Return the Gas Collector Box to its original hori

zontal position, secure the Inside Nut and try the

Electrode Check again.

5. if no "clicking" sound is heard check the following

common causes. If you need assistance caii our

Grill Information Center

at 1-888-317-7642.

* Ignitor AA battery not installed property.

* Electric wires may be loose. Remove the AA

battery, inspect the Ignitor Junction Box found

behind the Control Panel, and connect any loose

wires.

Figure 4 - Side View Figure

GAS COLLECTOR BOX

Installing Cooking Components

Important: Before cooking on your grill the first

time, wash the Cooking Grids and Cooking Rack

vwth warni, soapy water. Rinse and dry thoroughly.

After cooking is completed, turn grill to HIGH

setting three to five minutes to bum off rear grease

or food readue.

1. Place the three Stainless Steel Flame Tamers

on the lower ledge above Burners. See Figure 5.

2. Evenly space the Stainless Steel Cooking Grids

(cross braces are bottom side) on the ledge

above the Flame Tamers.

3. Place the Stainless Steel Secondary Cooking

Rack into the slots on the upper left and

upper right of Grill Bowl Side Panels. See

Figure 5.

4. Remove Fastening Band from Pot Support and

place the Pot Support into the Side Burner

Body-Inner. See Figure 5.

Figure 5

S/S SECONDARY

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

Comments to this Manuals

No comments

Kenmore ELITE 141.16681 User Manual Page 11

Comments to this Manuals

Related products and manuals for Grills Kenmore ELITE 141.16681