Kenmore 141.166801 User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 34
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
CAUTION: bevVARE OF FLASHBACK
CAUTION: Spiders and small insects occa
sionally spin webs or make nests in the grill
Burner Tubes during transit and warehousing.
These webs can lead to a gas flow obstruc
tion which could result in a fire in and around
the Burner Tubes. This t^^e of fire is known
as a "FLASHBACK" and can cause serious
damage to your grill and create an unsafe
operating condition for the user.
To reduce the chance of "FLASHBACK", you
must dean the burner tubes before assem
bling your grill, and at least once a month in
late summer or early fall when spiders are
most active. Also perform this Burner Tube
cleaning procedure if your grill has not been
used for an extended period of time.
Flashback Prevention
To reduce the chance of "FLASHBACK" {see
CAUTION at right) clean the Burner Tubes and
Burners before fully assembling your grill.
Remove the Cotter Pin from the rear underside
of each Burner using a pair of long nose pliers.
Carefully lift each Burner up and away from the
Gas Valve Orifice, then refer to Figure 1 and
perform one of these three cleaning methods:
1.
Bend a stiff wire, (a lightweight coat hanger
works well) into a small hook as shown
below. Run the hook through the Burner Tube
and inside the Burner several times to remove
any debris.
C
>
2.
3.
Use a bottle brush with a flexible handle.
Run the brush through the Burner Tube and
inside the Burner several times, removing any
debris.
Use an air hose to force air through each
Burner Tube. The forced air should pass
debris or obstructions through the Burner and
out the Ports.
Figure 1
A WARNING
The location of the Burner Tube with re
spect to the Orifice is vital for safe opera
tion. Check to ensure the Orifice is inside
the Burner Tube before using your gas grill.
See Fig. 2. If the Burner Tube does not fit
over the Valve Orifice, lighting the Burner
may cause explosion and/or fire.
Figure 2
GAS VALVE ASSEMBLY
ORFICE BURNER TUBE
Tools Required for Assembly
#2 phiiiips screwdriver
Protective work gloves
Eye protection
Utility knife
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 33 34

Comments to this Manuals

No comments