Kenmore 141.15227 User Manual download pdf (Page 14)

Installing Cooking Components

Figure 12

Important: Before cooking on your grill the first

time, wash the Cooking Grids and Cooking Rack

with warm, soapy water. Rinse and dry thoroughly.

Season with cooking oil regularly. After cooking is

completed, turn grill to HIGH setting three to five

minutes to burn off excess grease or food residue.

1. Place the two Flame Tamers on the lower

ledge above Burners. See Fig. 12.

2. Evenly space the Cooking Grids (cross braces

are bottom side) on the ledge above the

Flame Tamers.

3. Place the Secondary Cooking Rack into the

slots on the upper left and upper right of Grill

Bowl Side Panels. See Fig. 12.

4. Install the Smoker Drawer into the opening on

the upper left side of Control Panel. Slide the

Smoker Drawer on the Smoker Drawer Bracket

inside grill.

Connecting A Liquid Propane Gas (LPgas)

Tank To Your Grill

1. Open the front Doors of cabinet. Puli out the

LPG Tank Pull-Out Tray. Place the 20 lb tank

with foot ring into the hole in the tray. See

Fig.13a. Make sure the tank valve is in the

OFF positon.

Align the tank so the Tank Valve faces the

rear right corner of cabinet. See Fig. 13a. Use

the 1/4"x4" Wing Bolt to secure gas tank.

2. Check the tank valve to insure it has proper

external mating threads to fit the hose &

regulator assembly provided (Type 1 connection

per ANSI Z21.58a-1998). See Fig.13b (on page

15)

3. Make sure ai

position.

Burner Valves are in the OFF

4, Inspect the valve connection port and regulator

assembly. Look for damage or debris. Remove

any debris. Inspect hose for damage. Never

use damaged or plugged equipment.

5, Place the hose and regulator assembly through

gap between the Right Cart Leg and

the Grill Head. When connecting the hose and

regulator assembly to the tank valve (See Fig.

13b) hand tighten Quick Coupling Nut clockwise

to a full stop. DO NOT use a wrench to

tighten because it could damage the Quick

Coupling Nut and result in a hazardous

condition.

6, Open the tank valve fully (counterclockwise).

Use a soapy water solution to check alt

connections for leaks before attempting to light

your grill. See "Checking for LP Gas Leaks"

on page 15. If a leak is found, turn the tank

valve off and do not use your grill until the

leak is repaired.

SECONDARY

COOKING RACK

DRAWER

Figure 13a

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 32 33

Comments to this Manuals

No comments

Kenmore 141.15227 User Manual Page 14

Comments to this Manuals

Related products and manuals for Grills Kenmore 141.15227