Kenmore 141.15227 User Manual download pdf (Page 10)

Install the Door Bracket to the inside of front

Cart Legs. Align the threaded holes on the Door

Bracket with the holes on Cart Legs. Tighten

securely by using 4 of the 1/4"x2" Pattern Head

Screws provided. (See Fig. 3. on page 9) Upper

door bolt holes (at ends of bracket) must face

outward.

Installing The Cabinet Doors

1. Install the Door Stops to the Bottom Shelf

and the Door Bracket. See Fig. 4

Align the holes on the Door Stops with the

threaded holes on the top of the Bottom Shelf

and bottom side of Door Bracket. Tighten

securely by using 4 of the 1/4"x1/2'' Pattern

Head Screws provided. See Fig.4.

2. Remove the white protective film from the

stainless steel Doors. Attach a Door Handle to

each Front Door by using 2 of the M4x5mm

Pattern Head Screws provided. See Fig. 5. Be

careful not to scratch the Door surfaces.

3. When installing the Front Doors, make sure

the door bolt holes are located on the hinge

sides of the Cart Legs.

4. Install either Front Door by inserting 1/4"x1/2"

part-threaded bolt through the lower door bolt

hole of the Front Door and into the tapped

hole of the Bottom Shelf. Next, align the

upper door bolt hole of Front Door with the

tapped hole in the bottom of Door Bracket.

Insert 1/4"x1/2" part-threaded bolt provided and

tighten both securely.

5. Repeat these steps to install the other Front Door.

Figure 4

Figure 5

DOOR

instailing The Griil Head

1. Now that you've assembled the grill cart you

can install the pre-assembled Grill Head. See

Fig. 6. If you haven't already done so, we

suggest you open the Grill Lid and remove

the packed components. Even with the com

ponents removed, this next step requires 2

people.

With an assistant, lift and position the Grill

Head onto the grill cart. Align the 4 holes of

the Bowl Side Panel to the threaded holes

on the Cart Leg Bracket. Secure firmly by

using 4 of the 1/4"x1/2" Pattern Head Screws

provided.

2. Place the Pre-assembled Valve Kit and Ignition

Wire through the slot in side of Grill Head as

illustrated in Fig. 6.

3. Place Heat Shield into Grease Draining Tray.

The Heat Shield must be present and

centered for your safety. From the back

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 32 33

Comments to this Manuals

No comments