Kenmore 141.229952 User Manual download pdf (Page 10)

Assembly Instructions

Before assembling the patio heater, use the parts

list to check that all necessary parts have been

included. Inspect patio heater for damage as you

proceed. Do not assemble or operate the patio

heater if it appears damaged. If you have ques

tions during the assembly process, call 1-888-317

7642, 8am - 8pm CST, Monday through Friday.

CAUTION;

While it is possible for one person to assemble

this patio heater, we recommend you have assis

tance when attaching the Reflector, heater Head

Assembly and threading the stainless Fuel Hose.

Remove all parts and hardware from carton. Refer

to the parts list and hardware pack illustrations

and assemble the patio heater on a protective

work surface to avoid scratching heater surfaces.

1. Unscrew the three 3/8"x1-1/4" Hex Head

Screws from the Weighted Base.

Loosely install the two Legs with Hooks onto

Weighted Base by using 2 of the 3/8" Spring

Washers and the detached 3/8''x1-1/4" Hex

Head Screws. Make sure the Hooks are in

the front for the Safety Chain. See Fig. 1.

Loosely install the third Leg using a 3/8"

Spring Washer and the detached 3/8"x1-1/4"

Hex Head Screw.

2. Hang the Safety Chain on the Hooks of both

Legs.

3. Attach the Lower Post (with bracket) onto the

top of Legs by using 5 of the 3/8"x3/4" Hex

Head Screws, 10 of the 3/8" Spring Washers

and 5 of the 3/8" Cap Nuts in sequence as

shown in Fig. 2. Use adjustable wrench to

tighten the Nuts.

4. Secure Hose Holder A to the right Leg using

1 of the 3/8"x3/4" Hex Head Screw, 2 of the

3/8" Spring Washers and 1 of the 3/8" Cap

Nut. See Fig. 2. Use adjustable wrench to

tighten the Nut.

5. Tighten the loosely attached screws from

Steps 1, 3 and 4.

6. Straighten the Corrugated Stainless Steel Fuel

Hose and insert it through the Upper Post as

shown in Fig. 3.

With another person holding the Upper Post

upright, attach the Heater Head Assembly to

the top of Upper Post using 4 of the T4x15

Self-Tapping Screws provided.

Tools Required for Assembly

• Protective gloves

• Eye protection

• One #2 Phillips Head Screwdriver

• Two Adjustable Wrenches

Figure 1

3/8"x1-1/4" HEX HEAD SCREW DETACHED

FOR LEG INSTALLATION

Figure 3

HEATER HEAD

INSIDE

10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments