Kenmore 141.229952 User Manual download pdf (Page 11)

/.Attach the Reflector onto Emitter Grid by

using 4 of the 1/4" Spring Washers and 1/4"

Wing Nuts provided. See Fig. 4.

8. Slide the Tank Cover through the Lower Post

and onto the Weighted Base. See Fig. 5.

9. Lift the assembled Upper Post and insert the

balance of the Fuel Hose through Lower Post.

10, Keep the Upper Post slightly lifted and turn it

until its screw hole faces the same direction

as the sliding channel of the Lower Post.

Slide Upper Post into Lower Post, until the

holes on both posts align. Tighten securely

using 1 of the T4x15 Self-Tapping Screws

provided.

11, Raise the Tank Cover and tilt it sideways until

it rests onto the bracket of the Lower Post.

Connect the hose end fitting of the Regulator

Assembly to the stainless steel Fuel Hose.

Tighten securely with two adjustable wrenches,

12, Carefully bend the stainless steel Fuel Hose

at a 90 degree angle. Hold the connected

hose fittings against the installed Hose Holder

A, and secure Hose Holder B to Hose Holder

A by inserting the Fastening Strip into the

slot of Hose Holder A. Tighten firmly using

the 3/16"x1/2" Phillips Head Screw, and the

3/16" Spring Washer and 3/16" Nut provided.

Use adjustable wrench to tighten the Nut,

Figure 4

<á

Figure 5

1 2 ... 6 7 8 9 10 11 12 13 14 15

No comments

Kenmore 141.229952 User Manual Page 11