Kenmore 84422 Owner's Manual download pdf (Page 9)

Install casters

1. To avoid damaging oor, use a large at piece of cardboard

from dryer carton. Place cardboard under entire back edge

of the dryer.

2. Firmly grasp dryer body and gently lay dryer on its side

on cardboard.

3. Screw casters into dryer base at four corners and

tighten securely.

4. Set the dryer upright. In doing so, be certain that the dryer

does not roll away from you.

Connect Vent

1. Connect vent to exhaust outlet.

Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure the vent is

clean. Dryer vent must t over dryer exhaust outlet and inside

exhaust hood. Check that vent is secured to exhaust hood with

a 4" (102 mm) clamp.

2. Roll dryer into its nal location. Avoid crushing or kinking

the vent.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see what was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check dryer’s nal location. Be sure vent is not crushed

or kinked.

5. Check that dryer is on a level surface.

6. Plug into a grounded 3 prong outlet.

7. Remove lm on the console and any tape remaining on dryer.

8. Remove tape from lint screen (located on inside back wall

of dryer).

9. Read “Using Your Dryer.”

10. Wipe dryer drum interior thoroughly with a damp cloth to

remove any dust.

11. To test the dryer, set the dryer on a full heat cycle (not an air

cycle) for 20 minutes and start the dryer.

If the dryer will not start, check the following:

■ Controls are set in a running or ON position.

■ Push to Start button has been rmly pressed.

■ Dryer is plugged into a grounded 3 prong outlet.

■ Household fuse is intact and tight, or circuit breaker has

not tripped.

■ Dryer door is closed.

12. When the dryer has been running for 5 minutes, open the dryer

door and feel for heat. If you feel heat, cancel cycle and close

the door.

If you do not feel heat, check the following:

■ Controls are set on a heated cycle, not an air cycle.

NOTE: You may notice an odor when dryer is rst heated. This

odor is common when the heating element is rst used. The odor

will go away.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Comments to this Manuals

No comments

Kenmore 84422 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Electric laundry dryers Kenmore 84422