Kenmore 76132 Owner's Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
10
DRYER CARE
Keep dryer area clear and free from items that would block
the air  ow for proper dryer operation. This includes clearing
piles of laundry in front of the dryer.
Cleaning the dryer interior
To clean dryer drum
1. Apply a liquid, non ammable household cleaner to the
stained area of the drum and rub with a soft cloth until
stain is removed.
2. Wipe drum thoroughly with a damp cloth.
Removing accumulated lint
From Inside the Dryer Cabinet
Lint should be removed every 2 years, or more often,
depending on dryer usage. Cleaning should be done
by a quali ed servicer.
From the Exhaust Vent
Lint should be removed every 2 years, or more often,
depending on dryer usage.
Cleaning the dryer location
Changing the Sensing Cycle settings
to increase or decrease drying time
If all your loads on all Automatic Cycles are consistently less dry
or more dry than you would like, you may change the default
settings to increase or decrease the default dryness level.
Your automatic drying settings can be adjusted to adapt to
di erent installations, environmental conditions, or personal
preference. This change is retained and will a ect all of your
Automatic Cycles, not just the current cycle/load. There are
5 drying settings, which are displayed using the time display:
0 Much wetter clothes, 30% less drying time.
1 Slightly wetter clothes, 15% less drying time.
2 Factory preset dryness level.
3 Slightly drier clothes, 15% more drying time.
4 Much drier clothes, 30% more drying time.
To change the drying settings:
NOTE: The settings cannot be changed while the dryer
is running or paused. The dryer must be in standby mode
(power is o ) to adjust the default settings.
1. Before starting a cycle, touch and hold DRY LEVEL
for 3 seconds.
2. Touch DRY LEVEL to select the dryness level shown in the
time display: 0, 1, 2, 3, or 4.
3. Touch START/PAUSE to save the new dryness level setting.
Cleaning the dryer interior (cont.)
3. Tumble a load of clean cloths or towels to dry the drum
OR
Use a micro ber cloth and hot water in a spray bottle to
clean the drum and a second micro ber towel to dry.
NOTE: Items that contain loose dyes, such as denim blue
jeans or brightly colored cotton items, may discolor the dryer
interior. These stains are not harmful to your dryer and will
not stain future loads of clothes. Dry these items inside out
to avoid drum staining.
Cleaning the lint screen
Every load cleaning
The lint screen is located in the dryer. A screen blocked by
lint can increase drying time.
To clean:
1. Pull the lint screen out of its holder. Roll lint o the screen
with your  ngers. Do not rinse or wash screen to remove
lint. Wet lint is hard to remove.
2. Push the lint screen  rmly back into place.
IMPORTANT:
n
Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
n
If lint falls o the screen into the dryer during removal,
check the exhaust hood and remove the lint. See “Venting
Requirements” in the Installation Instructions.
As needed cleaning
Laundry detergent and fabric softener residue can build up
on the lint screen. This buildup can cause longer drying times
for your clothes, or cause the dryer to stop before your load
is completely dry. The screen is probably clogged if lint falls
o while the screen is in the dryer.
Clean the lint screen with a nylon brush every 6 months,
or more frequently, if it becomes clogged due to a residue
buildup.
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comments to this Manuals

No comments