,Installation InstructionsInstrucciones de instalaciónInstructions d’installationEnglish / Español / FrançaisKenmore®Stainless Steel TubUndercounter D
10IMPORTANT: The drain hose connection of the disposer or a waste tee must be made before the drain trap and at least 20" (50.8 cm) above the flo
11 Option D, No waste disposer – with air gapPrepare DishwasherRemove and discard the foam blocks located above the front legs on each side of the dis
12Helpful Tip: Place cardboard under dishwasher until installed in cabinet opening to avoid damaging floor covering. Do not use door panel as a workta
13Make Power Supply Cord ConnectionOption A, Power Supply Cord:Route cord so that it does not touch dishwasher motor to lower part of dishwasher tub.
14Connect wires black to black and white to white, using UL Listed/CSA Approved twist-on wire connectors (included with power supply cord kit).Tighten
15Built-up floors: If the kitchen floor is higher than the cabinet opening's floor - for example, the kitchen floor tile does not extend into the
16Option B, Side Attachment For marble, granite, or other hard surface countertopsNOTE: Remove the brackets from the parts package.Break off the end o
17With another person holding the dishwasher to keep it from tipping, open and close the door a few times. If the door closes or falls open under its
18Align front of dishwasher door panel with front of cabinet doors. You may need to adjust alignment to be even with your cabinets.Check that leveling
19NOTE: To avoid vibration during operation, route the water supply line so that it does not touch the dishwasher base, frame or motor.Connect the ³⁄₈
2TABLE OF CONTENTSDISHWASHER SAFETY ...2INSTALLATION REQUIREMENTS ...
20After hose is connected, remove towel.Make Direct Wire Electrical ConnectionNOTE: If the power supply cord was connected earlier, proceed to “Secure
21Connect wires black to black and white to white, using UL Listed/CSA Approved twist-on wire connectors (not included).Tighten strain relief screws t
22Secure dishwasher to countertopLocate brackets on top of dishwasher and secure dishwasher to countertop with two, #10 x ¹⁄₂" Phillips-head scre
23Complete InstallationOption A, Install Access Panel - Plastic PanelPlace the plastic access panel against the dishwasher leg.Check that the lower ed
24Check that the lower edge of the lower panel contacts the floor. Adjust if necessary.Tighten access panel screws.Plug into a grounded 3 prong outlet
25Check Operation Read the Dishwasher User Instructions that came with your dishwasher. Check that all parts have been installed and no steps were s
3INSTALLATION REQUIREMENTSTools and Par tsGather the recommended tools and parts before starting installation. Read and follow the instructions provid
4Location RequirementsGrounded electrical supply required.Do not run drain lines, water lines or electrical wiring where they can interfere with or co
5
6Drain Requirements A new drain hose is supplied with your dishwasher. If drain hose is not long enough, use a new drain hose with a maximum length o
7INSTALLATION INSTRUCTIONSPrepare Cabinet Opening—Existing UtilitiesIf the water line and the cable extend to the locations shown, proceed to the “Ins
8Wood cabinet: Sand the hole until smooth.Metal cabinet: Cover hole with grommet included with power supply cord kit.Option B, Direct Wire:Helpful Tip
9Attach the water supply line (copper tubing or flexible braided line) to the hot water line using a connection configuration that is in compliance wi
Comments to this Manuals