Kenmore Elite 30'' Gas Cooktop 3230 Installation Guide download pdf (Page 9)

4. Adjust the "LOW" setting for regular surface

burner valves (Figure 10)

a. Push in and turn control to LITE until burner ignites.

b. Quickly turn knob to LOWEST POSITION.

c. If burner goes out, reset control to OFF.

d. Remove the surface burner control knob.

e. Insert a thin-bladed screwdriver into the hollow valve

stem and engage the slotted screw inside. Flame size

can be increased or decreased with the turn of the

screw. Turn counterclockwise to increase flame size.

Turn clockwise to decrease flame size. Adjust flame

until you can quickly turn knob from LITE to LOWEST

POSITION without extinguishing the flame. Flame

should be as small as possible without going out.

Counterclockwise

Clockwise

5. Adjust the "LOW" setting of the dual burner surface

valve (Figure 10) (some models):

Note: On the dual valve the low setting of each portion

should be adjusted individually.

a. Push in and turn knob to LITE then continue to turn

until only the inner portion of the dual burner stays on.

b. QulckJy turn knob to LOWEST POSITIQN.

c. If burner goes out, reset control to OFF.

d. Remove the surface burner control knob.

e. The inner portion of the dual burner flame size

can be increased or decreased with the turn of the

screw B. Use screw A to adjust the low flame size

of the outer portion of the dual burner. Turn the

screw counterclockwise to increase flame size. Turn

the screw clockwise to decrease flame size. Adjust

flame until you can quickly turn knob from HIGH to

LOWEST POSITION without extinguishing the flame.

Flame should be as small as possible without going

out.

Note: Air mixture adjustment is not required on surface

burners.

When All Hookups are Complete

Make sure all controls are left in the OFF position.

Make sure the flow of combustion and ventilation air to

the cooktop is unobstructed.

Regular

Burner

Valve

Figure 10

Note: Air mixture adjustment is not required on surface

burners.

Model and Serial Number Location

The serial plate is located on the underside of the

cooktop.

When ordering parts for or making inquires about your

range, always be sure to include the model and serial

numbers and a Jot number or letter from the serial plate

of your cooktop.

Your serial plate also tells you the rating of the burners,

the type of fuel and the pressure the cooktop was

adjusted for when it left the factory.

Before You Call for Service

Read the Before You Call for Service Checklist and

operating instructions in your Use and Care Guide.

It may save you time and expense. The list includes

common occurrences that are not the result of defective

workmanship or materials in this appliance.

Refer to the warranty in your Use and Care Guide for

our service phone number and address. Please call or

write if you have inquiries about your product and/or

need to order parts.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments

Kenmore Elite 30'' Gas Cooktop 3230 Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Cookers Kenmore Elite 30'' Gas Cooktop 3230