Kenmore 580.75050 User Manual download pdf (Page 7)

INSTALLATION

Q INSTALL THE AIR CONDITIONER IN THE

WINDOW

• Carefully lift the air conditioner and slide it into the open

window. Make sure the bottom guide of the air

conditioner drops into the notches of the L brackets.

• When the air conditioner drops into the L brackets, the

air conditioner wiii be centered in window opening as

shown in FiG. 7.

• While steadying the air conditioner, carefully bring the

window sash down behind the upper guide of the air

conditioner, as shown in FIG. 8.

SECURE THE GUIDE PANELS

Extend the guide panels (ITEM G) to fill the window

opening using 2 ITEM B and 2 ÍTEM C screws to secure

them, as shown in FIG. 9.

INSTALL THE FOAM SEAL AND SASH LOCK

Cut the foam seal (ITEM F) to the window width.

Stuff the foam seal between the lower and upper

window sash to prevent air and insects from getting into

the room, as shown in FIG. 9.

Fasten the remaining L bracket on either side of the

window using screw (ITEM A). See FIG. 9 inset.

Installing this bracket prevents unit falling from window

being raised.

IF AIR CONDITIONER IS BLOCKED BY STORM

WINDOW FRAME

If storm window presents interference, fasten a 2" wide

wood strip to the inner window sill across the full width of

the sill. The wood strip should be thick enough to raise

the height of the window sill so that the unit can be

installed without interference from the the storm window

frame. See FIG. 10.

Top of wood strip should be approximately 3/4" higher

than the storm window frame to help condensation to

drain properly to the outside.

Install a second wood strip (approximately 6" long by

1V2" wide and same thickness as first strip) in the center

of the outer sill flush against the back of the inner sill.

Screw the L brackets into this strip.

This will raise the L bracket as shown in FIG. 10.

WOOD STRIP MOUNTED

1" MAX

ON TOP Of INNER SILL

3/4" I

CLEARANCE f

------

WINDOW

INNER

SILL

LBRACKEy

L FRAME

WOOD STRIP

FORI BRACKET V

OUTER

SILL

INSID E 1 OUTSIDE FIG. 10

REMOVAL FROM WINDOW

Turn the air conditioner off, and disconnect the power

cord. Remove the L bracket and the screws installed

through the top and bottom of the guide panels, and save

for reinstallation later. Close the guide panels. Keeping a

firm grip on the air conditioner, raise the sash, and

carefully tilt the air conditioner away from you to drain any

condensate water. Lift the air conditioner from the window

and remove the foam seal from between the windows.

A CAUTION

■ Air conditioners covered in this manual pose an

excessive weight hazard. Two or more people are

needed to move and install the unit.

To prevent injury or strain, use proper lifting and

carrying techniques when moving unit.

’ When handling the air conditioner, be careful to avoid

cuts from sharp metal fins on front and rear coils.

■ Make sure air conditioner does not fall during removal.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

Kenmore 580.75050 User Manual Page 7

Comments to this Manuals

Related products and manuals for Conditioners Kenmore 580.75050