Kenmore 580.75050 User Manual download pdf (Page 5)

INSTALLATION

INSTALLATION REQUIREMENTS installation hardware

Your air conditioner will install into standard double

hung windows with actual clear opening widths of

21 to 35 inches (533mm to 889mm) (FIG. 1).

Lower sash must open sufficiently to allow a clear

vertical opening of 12 inches (305mm). Side louvers

and the rear of the air conditioner must have clear

air space to allow enough airflow through the

condenser for heat removal. The rear of the unit

must be outdoors, not inside a building or garage.

Check your available electrical service. The power

supply available must be the same as that shown

on the unit nameplate (found on left side of cabinet).

All models are equipped with a 3-prong service plug

to provide proper service and safe positive

grounding. Do not change plug in any way. Do not

use an adapter plug. If your present wall outlet does

not match your plug, call a qualified electrician to

make the necessary corrections. SAVE CARTON

and this OWNER'S MANUAL for future reference.

The carton is the best way to store unit during

winter or when not in use.

A CAUTION

To avoid risk of persona! injury, property damage, or

product damage due to the weight of this device and

sharp edges that may be exposed:

• Air conditioners covered in this manual pose an

excessive weight hazard. Two or more people are

needed to move and install the unit.

To prevent injury or strain, use proper lifting and

carrying techniques when moving unit.

• Carefully inspect location where air conditioner will

be installed. Be sure it will support the weight of

the unit over an extended period of time.

• Handle air conditioner with care. Wear protective

gloves whenever lifting or carrying the unit, AVOID

the sharp metal fins of front and rear coils.

• Make sure air conditioner does not fall during

installation.

ITEM NAME OF PARTS Q'TY

A SHORT SCREW 14

B WOOD SCREW 2

C WOOD SCREW 2

D L BRACKET 3

E FOAM STRIP 1

F FOAM SEAL 1

G SIDE CURTAIN 2

H UPPER GUIDE 1

1 DRAIN PIPE 1

REQUIRED TOOLS:

• Tight Fitting gloves

• 3/8-inch open end

• Standard screwdriver

wrench or adjustable

wrench

• Phillips screwdriver

• 1/4-inch hex socket

• Pliers

and ratcher

• Sharp knife

• Tape measure

• Electric drill

• 1/4-inch drill bit

-5-

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments

Kenmore 580.75050 User Manual Page 5

Comments to this Manuals

Related products and manuals for Conditioners Kenmore 580.75050