Kenmore 580.72184 User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 23
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
INSTALLATION
Pick a location which will allow you to blow the cold
air into the area you want, Windows used for
installation must be strong enough to support the
weight of the air conditioner. Good installation with
special attention to the proper position of the unit
will lessen the chance that service will be needed.
When cooling more than one room, installation
location is very important since cold air will not turn
corners. To cool your rooms, cold air must be blown
from the air conditioner in a straight path.
HOW TO INSTALL
B Remove the screws which fasten the cabinet at
the back and side of the unit. Save side screws.
Discard back screws.
_] Insert the side curtain(ITEM A) into the upper guide
and lower guide of the air conditioner. Fasten the curtains
to the unit with screws (ITEM E).
Lower Guide
_Open the window.Mark a line on the center ofthe
window inner sill, Loosely attach the sill bracket (ITEM C)
to the support bracket (ITEM B) using the carriage bolt
(ITEM I) and the lock nut (ITEM D).
FIG. 3
B Slide the unit out of the cabinet by gripping the
base pan handle and pull forward while bracing the
_abinet.
FIG. 4
_Cut the FOAM STRIP (ITEM J) to fit the
underside of the window sash. Peel off the backing
and attach the FOAM STRIP as shown in Fig. 5.
ITEMI
_ Attach the sill bracket to the window sillusing the
screws (ITEM F). Carefully place the cabinet on the
window inner sill and align the center mark on the
angle front with the center line marked on the window
lner sill.
trackhole
screw
nut
Outer
windowsill
Carriagebolt F
andlocknut Sill FIG. 8
BUsing the M-screw (ITEM H) and the lock nut
(ITEM D), attach the support bracket to the cabinet
track hole. Use the first track hole after the sill bracket
on the outer edge of the window sill, Tighten the
carriage bolt and the lock nut, Be sure the cabinet
slants downward 1/4" from level.
CAUTION: Do not drilla hole in the bottom pan, The
unit is designed to operate with approximately 1/2" of
water in bottom pan.
FIG. 5
Cabinet
INDOOR OUTDOOR FIG, 9
-6-
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 22 23

Comments to this Manuals

No comments