Kenmore 580.72184 User Manual download pdf (Page 5)

INSTALLATION REQUIREMENTS

Your air conditioner will install into standard double

hung windows with actual clear opening widths of

29 to 4t inches (737mm to 1041mm) (FIG, 1)

Lower sash must open sufficiently to allow a clear

vertical opening of 18 inches (457mm). Side louvers

and the rear of the air conditioner must have clear

air space to allow enough airflow through the

condenser for heat removal. The rear of the unit

must be outdoors, not inside a building or garage,

Interiorwall ..- FIG. t

ELECTRICAL SERVICE

Check your available electrical service. The power

supply available must be the same as that shown on

the unit nameplate (found on right side of cabinet).

All models are equipped with a 3-prong service plug

to provide proper service and safe positive

grounding, Do not change plug in any way. Do not

use an adapter plug, If your present wall outlet does

not match your plug, call a qualified electrician to

make the necessary corrections.

SAVE CARTON and this OWNER'S MANUAL for

future reference. The carton is the best way to store

unit during winter or when not in use.

To avoid risk of personal injury,property damage,

or product damage due to the weightof this

device and sharp edges that may be exposed:

• Air conditioners covered in this manual pose an

excessive weight hazard. Two or more people

are needed to move and install the unit.

To prevent injury or strain, use proper lifting and

carrying techniques when moving unit.

• Carefully inspect location where air conditioner

will be installed.Besure it will support the

weight of the unit over an extended perior of

time.

° Handleair conditioner with care. Wear

protective gloves whenever lifting or carrying the

unit. AVOID the sharp metal finsof front and

rear coils.

° Make sure air conditioner does not fall during

installation.

INSTALLATION HARDWARE

A B C D E

F G H I J K

FIG. 2

ITEM NAME OF PARTS Q'TY

A SIDE CURTAIN 2

B SUPPORT BRACKET 2

C SILL BRACKET 2

D LOCK NUT 4

E SCREW: 25/64" 11

F SCREW: 13/1#` 7

G SCREW: 9/16" 5

H M-SCREW 2

I CARRIAGE BOLT 2

J FOAM STRIP 1

K FOAM SEAL 1

L WINDOW LOCKING BRACKET 1

M DRAIN PIPE 1

REQUIRED TOOLS:

° Tight Fitting gloves

• Standard screwdriver

• Phillips screwdriver

• Pliers

• Sharp knife

• 3/8-inch open end wrench or adjustable wrench

• 1/4-inch hex socket and ratcher

• Tape measure

° Electdc drill

° 1/4-inch drill bit

-5-

1 2 3 4 5 6 7 8 9 10 ... 22 23

Comments to this Manuals

No comments

Kenmore 580.72184 User Manual Page 5

Comments to this Manuals

Related products and manuals for Air filters Kenmore 580.72184