Kenmore 625.38454 User Manual download pdf (Page 7)

step 4 - Make Tubing Connections

This system includes push-to-connect fittings for quick

tubing connections at most locations. To make tubing

connections with the fittings, do the following:

1. Allowing some slack, measure and cut a length of 1/4"

tubing to connect between the supply fitting and the

filter system inlet (See Figure 1). Use a sharp cutter or

knife to cut the end of tubing square.

2. Inspect the tubing, about 1" from end, to be sure there

are no nicks, scratches or other rough spots. If needed

cut the tubing again.

3. Push tubing through the collet and all the way into fit

ting. Full engagement is 11/16" for 1/4" tubing. Pull

on the tubing to be sure that it is held firmly in the fit

ting.

If more tubing is required, see parts list at the end of this

manual.

Push-to-connect Fitting

Tube.

Cut tubing square with end of tubing round,

smooth, with no cuts, nicks or flat spots.

Tube Correctly Cut

Figure 5

Collet

O-Ring

Tube Partially Engaged With Fitting

Figure 6

TO DISCONNECT TUBING:

Push the collet and hold, then pull the tubing out (See

Figure 8).

NOTE:

DO NOT USE VINEGAR, OR OTHER ACID

BASED CLEANERS ON THIS SYSTEM.

THEY WILL DEGRADE SOME SYSTEM

PARTS. ALWAYS USE SOAP AND WATER.

Collet

O-Rlng

Tube Fully Engaged With Fitting

Push Collet to

Remove Tubing)

Figure 7

Tubing

Disconnect Tubing

Figure 8

To complete the installation, turn to page 8 and follow the filter cartridge installation steps.

Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Kenmore 625.38454 User Manual Page 7

Comments to this Manuals

Related products and manuals for Water equipment Kenmore 625.38454