Kenmore 3.6 cu. ft. Top-Load Washer w/ Deep Wash Cycle - White ENERGY STAR Installation Guide download pdf (Page 3)

You will need:

A water heater set to 120° F (49° C).

A grounded electrical outlet located within 4 ft (1.2 m) of

power cord on back of washer.

Hot and cold water faucets located within 3 ft (0.9 m) of hot

and cold water ll valves on washer, and water pressure

of 20-100 psi (138-690 kPa).

A level oor with maximum slope of 1" (25 mm) under entire

washer. Installing on carpet is not recommended.

Floor must support washer’s total weight (with water and load)

of 315 lbs (143 kgs).

IMPORTANT: Do not install, store, or operate washer where it

will be exposed to weather or in temperatures below 32° F (0° C).

Water remaining in washer after use may cause damage in low

temperatures. See “Washer Care” in your Use and Care Guide

for winterizing information.

Proper installation is your responsibility.

LOCATION REQUIREMENTS

Select proper location for your washer to improve performance

and minimize noise and possible “washer walk”. Install your

washer in a basement, laundry room, closet, or recessed area.

Recessed area or closet installation

Dimensions show recommended spacing allowed, except for

closet door ventilation openings which are minimum required.

This washer has been tested for installation with spacing of

0" (0 mm) clearance on the sides. Consider allowing more space

for ease of installation and servicing, and spacing for companion

appliances and clearances for walls, doors, and oor moldings.

Add spacing of 1" (25 mm) on all sides of washer to reduce

noise transfer. If a closet door or louvered door is installed, top

and bottom air openings in door are required.

42"

(1067 mm)

27"

(686 mm)

/2"

(648 mm)

17"

(432 mm)

(126 mm)

14" max.

(356 mm)

(76 mm)

24 in.

(155 cm

)

48 in.

(310 cm

)

(25 mm)

Parts needed: (Not supplied with washer)

To order, please refer to toll-free phone numbers on back page

of your Use and Care Guide.

8212656RP 10 ft. (3.0 m) Inlet hose, Black EPDM (2 pack)

8212641RP 5 ft. (1.5 m) Inlet hose, Black EPDM (2 pack)

8212546RP 4 ft. (1.2 m) Inlet hose, Black EPDM (2 pack)

8212545RP 5 ft. (1.5 m) Inlet hose, Red and Blue EPDM

(2 pack)

8212487RP 5 ft. (1.5 m) Nylon braided inlet hose (2 pack)

8212638RP 6 ft. (1.8 m) Nylon braided inlet hose, space

saving 90° elbow, hypro-blue steel couplings

(2 pack)

8212637RP 6 ft. (1.8 m) Inlet hose, Black EPDM, space

saving 90° elbow, hypro-blue steel couplings

(2 pack)

Alternate parts: (Not supplied with washer)

Your installation may require additional parts. To order, please

refer to toll-free numbers on back page of your Use and Care

Guide.

If you have: You will need:

Overhead sewer Standard 20 gal. (76 L) 39" (990 mm)

tall drain tub or utility sink, sump

pump and connectors (available from

local plumbing suppliers)

1" (25 mm) standpipe 2" (51 mm) diameter to 1" (25 mm)

diameter Standpipe Adapter

Part Number 3363920

Connector Kit Part Number 285835

Drain hose too short Extension Drain Hose Part

Number 285863

Connector Kit Part Number 285835

Lint clogged drain Drain Protector Part Number 367031

Connector Kit Part Number 285835

Inlet hoses with

flat washers

1 2 3 4 5 6 7 8 ... 23 24

Comments to this Manuals

No comments

Kenmore 3.6 cu. ft. Top-Load Washer w/ Deep Wash Cycle - White ENERGY STAR Installation Guide Page 3

Comments to this Manuals

Related products and manuals for Washing machines Kenmore 3.6 cu. ft. Top-Load Washer w/ Deep Wash Cycle - White ENERGY STAR