Kenmore 26-25132 Installation Manual download pdf (Page 7)

Run water for a few seconds through hoses into a laundry tub,

drainpipe, or bucket to prevent clogs. Water should run until clear.

Attach hot water hose to hot water inlet valve marked with a

red ring. Screw coupling by hand until it is snug. Use pliers to

tighten couplings an additional two-thirds turn. Repeat with

cold water inlet valve.

IMPORTANT: To reduce risk of hose failure, replace the hoses

every 5 years. Record hose installation or replacement dates

for future reference.

Periodically inspect and replace hoses if bulges, kinks, cuts,

wear, or leaks are found.

Turn on water faucets to check for leaks. A small amount of

water may enter washer. It will drain later.

10. Connect inlet hoses to washer

11. Check for leaks

9. Clear water lines

Secure drain hose to laundry tub leg, drain standpipe, or inlet

hoses for wall standpipe with beaded tie strap.

LEVEL WASHER

IMPORTANT: Level washer properly to reduce excess noise

and vibration.

Move the washer to its nal location. Place a level on

top edges of washer. Use side seam as a guide to check

levelness of sides. Check levelness of front using lid, as

shown. Rock washer back and forth to make sure all four

feet make solid contact with oor. If washer is level, skip to

step 15, (on models with metal feet) or step 16 (on models

with plastic feet).

13. Check levelness of washer

Place level here

Not Level LEVEL Not Level

12. Secure drain hose

4.5"

(114 mm)

4.5"

(114 mm)

4.5"

(114 mm)

Laundry Tub Standpipe Wall

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Kenmore 26-25132 Installation Manual Page 7